Abstract:The control of welding distortion during assembly process is very important. At present, there are mainly two numerical simulation methods for the welding distortion which are thermo-elastic-plastic finite element method and its simplified approach of inherent strains. At first, taking T-joint as an example, the welding distortions were computed using two methods mentioned above. Based on thermo-elastic-plastic finite element method, welding process was simulated by life and death element, moving heat source and transient state thermal field etc. Then, the welding distortion was calculated by inherent strains method after thermo-elastic-plastic computation. It was concluded from the comparison that the simulation results by using the two methods are consistent. Therefore, the inherent strains method can be conveniently and economically applied to prediction of structural welding distortion in engineering. Applied the inherent strains method, welding deformation was predicted for the bogie frame side beam of high speed train. According to the deformation results from the finite element analysis, the welding deformation of the bogie frame side beam was lager than the tolerance of quality and in reasonable agreement with the experimentally determined distortion values. The work in this paper indicated that the inherent strains method was effective to predict the welding deformation so as to control the welding quality in large complex structures, such as the bogie frame of railway vehicle. Key words: welding distortion; thermo-elastic-plastic method; inherent strains approach; numerical simulation; bogie frame;

Numerical Simulation Analysis of Deformation in TIG Welding of I-Steel

Simulation and Analysis on Longitudinal TIG Welding of TC4 Titanium Alloy Thin-walled Circular Tube

Numerical Simulation of Welding Deformation for Hull Superstructure Steel Based on the Finite Element Analysis

Numerical simulation of welding deformation in weld on thin low carbon steel plate

Finite element simulation of temperature field for TIG butt welding of thin plate

Numberical Simulation of Welding Deformation under Different Conditions

NUMERICAL SIMULATION OF PENE-TRATED WELD POOL GEOMETRY AND SURFACE DEFORMATION IN TIG WELDING

Numerical Simulation of Temperature Fields for T-joint During TIG Welding of Titanium Alloy

Study on FEM Numerical Simulation Method for the Welding Distortion

Numerical Simulation of Welding Distortion in Large Structures

Numerical Simulation of Welding Distortion under Different Sequences

Finite Element Analysis on -D Molten Pool Geometry for GTAW Based on SYSWELD Software

Numerical Simulation of Welding Temperature Field, Residual Stress and Deformation Induced by Electro Slag Welding

Numerical Simulation of Tube-Plate Welding Structure with T-Shaped Sections

Investigating the Influence of External Restraint on Welding Distortion in Thin-Plate Welded Structures by Means of Numerical Simulation Technology

Numerical Simulation and Experimental Study on Residual Stress in T Type Welding of Thin Plates

Numerical Simulation and Experimental Validation of Angular Distortion and Residual Stresses in A T-Joint

Numerical Simulation of Tungsten Inert Gas Welding of 5A12 Aluminum Alloy Limited Size Sheet

Numerical Simulation of Arc and Droplet Behaviors in TIG-MIG Hybrid Welding

3D Finite Element Analysis of Temperature Field Distribution in TIG Welded 321 Stainless Steel Fillet Joint

Numerical Simulation of Weld Pool Geometry and Surfaces Deformation in GMAW