Abstract:Effects of addition of cationic high molecular weight polymers (CP) as a primary flocculant or coagulant aid,,on the treatment efficiencies for raw water with low temperature (T10℃) and low turbidity (C010 NTU) were measured. The raw water was obtained from the Qujiang water treatment plant in Xi′an, China and investigated using a micro-flocculation depth-bed direct filtration process. Fractal mathematics and image analysis were used to analyze the effects of the following factors on treatment efficiencies: filter medium; raw water turbidity and temperature; chemical type, molecular weight and dosage of polymer; and mixing strength. The flocculation mechanism, floc morphologies and the fractal properties of floc structures were also compared after adding different flocculants. Five important results were obtained: ① It is not suitable to use Al2(SO4)3 (AS) or polyaluminium chloride (PAC) alone when T4℃, C04 NTU. Fine sand filter medium should be used if Al2(SO4)3 or PAC is added alone under the conditions 4℃T10℃, C010 NTU. For raw water with low temperature and turbidity, the flocs formed from inorganic coagulants are small, loose and fragile structures, with low efficient mass density and settling rate, but high fractal dimension. ②A coarse sand filter markedly improved CP flocculation efficiencies of raw water with low temperature and turbidity; but the mixing strength should be increased due to high viscosity of CP; ③It is appropriate to use low molecular weight polymers with weakly cationic properties or a lower dosage of CP with strong cationic properties if CP serves as a primary flocculant. When CP is used as a coagulant aid, the dosage of the primary coagulant can be greatly decreased, but it is better to use high molecular weight polymers with strong cationic properties or to increase the dosage of CP with weak cationic properties. ④The flocculation mechanisms of CP are charge neutralization, adsorption and bridging. Flocs formed from CP have have large network configurations, which lead to reduced sludge volumes and increased sludge settling rates as well as good dewatering behavior, but have a lower fractal dimension than inorganic flocs. ⑤ The treatment efficiencies of all tested flocculants are as follows: Al2(SO4)3 (or PAC) +CP CPPAC Al2(SO4)3 .

Application Research on Treatment of Micro-Polluted Raw Water in Winter Western Mountainous Cities Using Composite Coagulants of PAC-PDM

Coagulation efficiency and removal mechanism for composite coagulant polyaluminium chloride/polydimethyldiallylammonium chloride in treating lightly micro-polluted raw water of Yangtze River in autumn

Optimization of pre-oxidation enhanced coagulation for micro-polluted water treatment by response surface method

Multiple Response Optimization of the Coagulation Process for Upgrading the Quality of Effluent from Municipal Wastewater Treatment Plant

Experimental Study on Application of PAC Produced Electrochemically in Water and Wastewater Treatment

Study on Treatment of Tiny Pollution Water with PAC-HUM System in Kuitun River

Optimization of polypropylene microplastics removal using conventional coagulants in drinking water treatment plants via response surface methodology

Optimization of the Coagulation-Flocculation Process for Pulp Mill Wastewater Treatment Using a Combination of Uniform Design and Response Surface Methodology

Enhanced Coagulation of Low-Turbidity Micro-Polluted Surface Water: Properties and Optimization.

The performance of enhanced coagulation for treating slightly polluted raw water combining polyaluminum chloride with variable charge soil

Enhanced Coagulation for High Alkalinity and Micro-Polluted Water: the Third Way Through Coagulant Optimization.

A Comparison of Polymeric Aluminum Chloride and a New Coagulant Containing Oxidants and Humic Acid for Municipal Wastewater Treatment

Study on treatment of algae-laden wasterwater using coagulation-micro bubble air flotation process

Removal of DBP Precursors in Micro-Polluted Source Waters: A Comparative Study on the Enhanced Coagulation Behavior

Study on the optimization of polyacrylamide wastewater treatment by coagulation-adsorption

Enhanced Coagulation/Flocculation by Combining Diatomite with Synthetic Polymers for Oily Wastewater Treatment

Preparation of composite coagulant for the removal of microplastics in water

Response of sediment microbial communities to different levels of PAC contamination and exposure time

Flocculation Efficiencies and Morphological Properties of Cationic Polymers in the Treatment of Low Temperature and Low Turbidity Raw Water

Purification of Micro Polluted Surface Water and Study on Membrane Fouling by PAC-UF Process

Enhanced Flocculation As the Pretreatment for Biopollutant Laboratory Wastewater