Abstract:Aiming at studying the harm caused by sudden ground loadings on existing shield tunnels, a indoor scaled model test with a geometric similarity ratio of 1:15.5 was adopted. Considering the influencing factors such as ground loading, burial depth of the shield tunnel, loading position and soil properties, tunnel convergence deformation, tunnel settlement and deep settlement of soil caused by sudden ground loadings are studied. A three-dimensional finite element simulation is carried out using the Midas software, and deep settlement of soil is calculated by a theoretical method. The purpose of this model test is to further understand the influence of ground surcharges on shield tunnel deformation. The results show that the greater the ground surcharge, the greater the settlement and vertical convergence deformation of the shield tunnel; The further away from the ground surcharge, the smaller the settlement, vertical convergence deformation and lateral convergence deformation of the tunnel. When the pile load size is constant, the greater the burial depth of the tunnel, the smaller the vertical convergence deformation and settlement of the tunnel; the maximum value of deep settlement of the soil always remains at the closest point to the ground surcharge; compared with the use of dry sand, the vertical convergence deformation and settlement of the tunnel are significantly reduced when using wet sand. Both the theoretical calculation results and the numerical simulation results are in good agreement with the indoor model test results.

The Effect of Calculating Gridding Size on the Formation of Multimode Penetrator

The Effect Of Shell Configuration On The Formation Of Multimode Penetrators

Strain-rate-dependent Cohesive Zone Modelling of Charge Damage Behavior when a Projectile Penetrates Multilayered Targets

Research on the Optimum Length–diameter Ratio of the Charge of a Multimode Warhead

Numerical Simulation and Analysis of a Combined Shaped Charge

Influence on Formation of Shaped Charge with a Center-hole

Numerical Simulation on Low Ratio Length to Diameter Shaped Charge Warhead

The Influence of Target Mesh on the Simulation Results of High Velocity Projectile Penetration

The effect of annular multi-point initiation on the formation and penetration of an explosively formed penetrator

Penetration Analysis of Driving Weapons Precursory Shaped Charge Based on LS-DYNA

Influence of the Movement of Cylindrical Target Plate on the Penetrating Ability of Kinetic Energy Projectile

Numerical Simulationand Analysis of a New Double Shaped Charge Liner Formed Penetrator

Numerical Simulation of Forming Projectile with K-charge

Model Test Study on the Influence of Ground Surcharges on the Deformation of Shield Tunnels

Research On The Rule Of Multi-Point Initiation Replacing Annulus Initiation Under Different Charge Caliber

Transformation Mechanism of Dual-mode Penetrators Achieved by Changing of Single-point Detonation

Formation and Penetration Properties of a Shaped Charge with Zr41.2Ti13.8Cu12.5Ni10Be22.5 Liner

The Influence of Closed-Cell W-Shaped Liner Parameters on the Penetration Performance of Integral Annular Shaped Charge

Numerical modelling of shaped charge jet penetration into ceramic–metal double-layered medium using smoothed particle hydrodynamics

Finite Element Analysis and Simulation of Oilfield Perforating Charge Penetration Depth

Study of penetration performance of embowed linear-shaped charge based on SPH method