Abstract:Alkali activated slag ultra-high performance concrete (AAS-UHPC) is a promising low-carbon cementitious material that can effectively utilize industrial solid waste and reduce pollutant emissions during the production of cementitious materials compared with ultra-high performance concrete (UHPC), and it also exhibits excellent mechanical properties. The objective of this study is to conduct a comparative experimental analysis of the workability, mechanical properties and deformation behavior of UHPC and AAS-UHPC. In this study, AAS-UHPC prepared with lower water/cement ratio (w/b) has good flowability, faster setting time and higher strength. Although the early hydration rate of AAS-UHPC was similar to that of UHPC, its cumulative heat of hydration was higher. In chemical shrinkage experiments, the shrinkage value of AAS-UHPC increased with increasing water bath temperature and remained at about twice the strain value of UHPC. The age-early drying shrinkage of AAS-UHPC can be divided into four phases: transient deformation, dormant, accelerated, and slow development. stage, accelerated stage and slow development stage. Self-shrinkage is divided into three stages: dormant stage, accelerated stage and slowly developing stage. Compared with ultra-high performance concrete, AAS-UHPC has a longer dormant phase of early age shrinkage, and the deformation in this phase is mainly plastic shrinkage. Starting from the accelerated stage, the relative humidity decreases rapidly due to the strong occurrence of hydration reaction and shrinkage of pore structure. This leads to a rapid increase in the modulus of elasticity of AAS-UHPC, which results in greater deformation. In the later stages, the rate of shrinkage development slows down due to the basic formation of the concrete skeleton.

Autogenous Volume Deformation and Creep Properties Analysis of C60 High Performance Concrete and C60 High Strength Concrete

Shrinkage and Creep of Sustainable Self-Compacting Concrete with Recycled Concrete Aggregates, Fly Ash, Slag, and Silica Fume

Creep Model of High-Performance Concrete at Different Loading Ages

Experiments on drying shrinkage and creep of high performance hybrid-fiber-reinforced concrete

Effects of Type and Content of Fibers, Water-to-Cement Ratio, and Cementitious Materials on the Shrinkage and Creep of Ultra-High Performance Concrete

STUDY OF THE CREEP BEHAVIOR OF HIGH STRENGTH SELF-COMPACTING CONCRETE

Decoupling of Autogenous Shrinkage and Tensile Creep Strain in High Strength Concrete at Early Ages

Calculation of Creep Deformation of Stiffness-Degraded RC Beams after Strengthening with Increased Cross-Section

Strength, shrinkage and creep of lightweight cementitious composite incorporating carbon nanofibers

Mechanical Properties and Durability of High-Performance Concretes Blended with Circulating Fluidized Bed Combustion Ash and Slag as Replacement for Ordinary Portland Cement

Current research status of UHPC creep properties and the corresponding applications – A review

Shrinkage and Creep Properties of Low-Carbon Hybrid Cement

Comparative research: early-age deformation of alkali-activated/cement-based ultra-high performance concrete

Shrinkage and Creep of High-Strength Lightweight Aggregate Concrete

Numerical Simulation of High-Strength Concrete Creep under Cyclic Load

Influence of Intensified Composite Grout on the Properties and Micro-deformation of C30 and C60 Recycled Concrete

Measurement and Modeling of Creep Property of High-Strength Concrete Considering Stress Relaxation Effect

Experimental Study on Flexural Bearing Characteristics of Ceramsite Concrete Beams after Creep at Different Curing Ages

Creep of alkali-activated cement mixtures

Durability and Compression Properties of High-Strength Concrete Reinforced with Steel Fibre and Multi-walled Carbon Nanotube

Concrete Shrinkage and Creep in Recycled Aggregate Concrete-Filled Steel Tubes