Abstract:A micro flying slider is developed to satisfy the demands for large capacity, high data density, and fast transfer rate of mass storage systems. The air-bearing surface of the micro flying slider is designed based on micro fluid theory of hydrodynamics to obtain positive and negative pressures, thereby enhancing flying height stability. The lubrication model is investigated based on the generalized Reynolds equation. The finite volume method is utilized to solve the revised Reynolds equation that governs the air-bearing pressure and flying system behavior. The dynamic model for the slider–disk interface of the micro flying slider is developed, and the air-bearing system is modeled as a 3-degrees-of-freedom, lumped-parameter model to simulate flying characteristics. The air-bearing pressures with flying attitudes in the loading/unloading processes are characterized and calculated using the proposed model, with flying height and pitch angle as the key variables. The sample data obtained via accurate triggering and superposed averaging are processed to acquire modal frequencies and damping ratios based on the parameter identification method of modal analysis technique. System experiments are presented to illustrate the effectiveness of the proposed micro flying slider and its dynamic model for flying-height control. Theoretical analysis and experimental results show that a stable storage working process can be obtained at 1600 rpm and a pitch angle of 1.5°. Moreover, the micro flying slider exhibits satisfactory flying stability, with a near-field working distance of less than 75 nm. Good correlation between the experimental and simulation results is achieved.

Surface Topology Optimization of Air Bearing Slider for Wear Durability in Magnetic Hard Disk Drives

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Simulation of Load/unload Process and Parameter Optimization for a Hard Disk Drive

Slider Dynamics and Wear Behaviors at Subnano-Clearance Head–Disk Interface

Numerical Simulation On Lubricant Recovery After Depletion

Numerical Analysis of the Lubrication Performances for Ultra-Thin Gas Film Lubrication of Magnetic Head/Disk with A New Finite Difference Method

Calculation and Analysis of Air Bearing Performance for Magnetic Head/Disks

Research on the Design and Fabrication of Air Bearing Sliders in Hard Disk Drives

Simulation of Dynamic Behavior of Slider at Head/Disk Interface of Hard Disk Drives

Investigation of Electrostatically Tunable Adhesion and Instability of Flying Head Slider

Optimum Topology Design of Sliders of High Storage Density Hard Disk

Dynamic Character of Ultra Thin Film Gas lubrication for Magnetic Head/Disk

Experimental Study of Head-Disk Interface Flyability and Durability at Sub-1-nm Clearance

Wear Study For Dual-Heater Slider Under High Temperature

Flyability and Durability Test of Dynamic Fly-Height Sliders at 1-Nm Clearance

Numerical simulation of the dynamic characteristics of the ultra-thin gas flow at the head/disk interface of hard disk drives

Simulation of Contact at Head and Multilayer Disk Interface under Quasi-Static Condition

Experimental Study of the Slider-Lube/Disk Contact State and Its Effect on Head-Disk Interface Stability

Analysis of Pressure Distribution on Head Disk Air Bearing Slider Involved Van Der Waals Force

Modeling, Design and Analysis of a Micro Flying Slider in Near-Field Optical Storage System

Effect of Low-Frequency Vibration in Z-Direction (Out-of-Plane) on Slider Dynamics