Abstract:Monitoring rotor blade vibrations is imperative in aero-engine testing and service. Blade tip timing (BTT), a promising technique for such monitoring, assesses the operational status of rotor blades through non-intrusive measurement of blade tip displacement. Traditional BTT technology relies on the Once-Per-Revolution (OPR) probe, which poses installation challenges and introduces measurement uncertainties in practical applications. This paper introduces a novel OPR-free approach, employing Adaptive Variable Reference Blades (AVRB) for non-intrusive measurement of rotor blade vibrations. The method assumes a stochastic mistuning of blades within the same stage, resulting in non-simultaneous resonance of blades at a given speed. In each revolution, the vibration level of individual blades is determined by assessing the deviation between the average speed of a blade, as measured by two adjacent BTT probes, and the average speed across the entire circumference. Consequently, a non-vibrating blade is adaptively identified and selected as the reference blade. The relative vibration levels among blades vary dynamically during different revolutions, influenced by mistuning features, leading to variability in the reference blades. These adaptive variable reference blades can then replace the OPR probe, aiding in the computation of vibration displacement and further parameter identification of blades. To validate the effectiveness of the proposed method, a five-degree-of-freedom numerical model is utilized for simulation. Additionally, experiments involving both a five-bladed disk and an eight-bladed disk are conducted to validate the proposed approach. Numerical simulations and two sets of test results demonstrate a fundamental agreement between the blade vibration displacement calculated using the proposed method and the outcomes obtained through the traditional BTT method with OPR. The relative error in the identified blade vibration frequency derived from the blade vibration displacement, as determined by both methods, does not exceed 1 %. Additionally, the relative error in the amplitude of the blade vibration displacement is within the range of 10 %.

Adaptive Planning Method for Measuring Points of Blade Section Line

Sampling point planning method for aero-engine blade profile based on CMM trigger probe

Study on Discrete Modeling Method of Modal Testing for Turbine Blade

An adaptive on-machine sampling strategy for blades based on modified equal chord height method

An adaptive sampling method for accurate measurement of aeroengine blades

An adaptive sampling methodology for measuring blades with CMM based on dominant feature points

Research on Tool Path Planning for NC Machining and Measurement Technology of a Blade Surface

Research on blade statistics measurement registration planning technology

A sampling method for blade measurement based on statistical analysis of profile deviations

An Efficient Automated Measurement Method for Aero-Engine Fan Blade Geometric Parameters

&Lt;title>new Method for the Measurement of Aeroengine Blade Edge</title>

Measuring the Profile of Aircraft Engine Blades Using Spectral Confocal Sensors

A New Methodology for Evaluating Profile and Position Errors of Blade Based on Parameter Priority

A High-Precision T-spline Blade Modeling Method with 2D and 3D Knot Adaptive Refinement

Blade Profile Extraction and Edge Completion Method Based on Structured Light Measurement Point Cloud

Bi-Directional Line Structured Light Scanning Measurement Method for Maximum Thickness of Aero-Engine Blade Cross-Sections Based on Profile Features

Research on Optimization of Sampling Feature Points for On-Machine Measurement of Integral Impeller Blade Profile

A Novel OPR-free Method for Blade Tip Timing Based on Adaptive Variable Reference Blades

Research on adaptive CNC machining arithmetic and process for near-net-shaped jet engine blade

Novel Sectional Profile Matching Algorithm for Gas Turbine Blades Based on Curve Chord-Length Invariant Feature

A global-to-local registration and error evaluation method of blade profile lines based on parameter priority