Abstract:The paper presents the results of metallographic analysis of the microstructure of high-alloy Uddeholm Sverker 3 steel (AISI Type D2). Cold treatment of high-alloy steels is used as a way to reduce the amount of retained austenite and, as a consequence, to stabilize the mechanical properties and dimensions of precision parts. In this work, we have used deep cold treatment by immersion in liquid nitrogen after heat treatment according to the traditional technology (quenching for primary hardness and low tempering). Exposure to liquid nitrogen has been carried out for 24 h. At the end of the exposure, the parts have been removed from liquid nitrogen and kept at room temperature until they reached room temperature. Then, the parts have been subjected to tempering at a low temperature of 170°C. The cryogenically treated sample has more noticeable fluctuations in the chemical composition and a larger amount of the carbide phase (30 and 27 vol %, respectively). Fluctuations in the chemical composition are expressed in more intense coloring of carbide particles using color etching, which indicates differences in their chemical composition. In the case of cryogenic treatment, the average specific size of carbides is less than in the absence of it. In addition, an increase in the content of ultrafine carbides is observed in the cold-treated sample, which is logically explained by their precipitation from retained austenite during its decomposition at cryogenic temperatures, decay of retained austenite and, as a result, the release of additional volumes of carbide particles. Particles formed during cryogenic treatment can be classified as ultrafine, with an average diameter of about 1 μm.

Analysis on the Microstructure of Carbide Reamers after the Cryogenic Treatment

Development and Advances in Cryogenic Treatment Technique and Device

The Effect of Cryogenic Treatment on Microstructure and Properties of WC–Co Cemented Carbides

Microstructure and mechanical properties in core of a carburizing 20CrNi2MoV bearing steel subjected to cryogenic treatment

Performance Analysis of TiAlSiN Coated Tungsten Carbide End Milling Tool Subjected to Shallow and Deep Cryogenic Treatments

A Review on Cryogenic Treatment of Tungsten Carbide (WC-CO) Tool

Hardness and toughness investigations of deep cryogenic treated cold work die steel

Increasing the Wear Resistance of Parts Made of High-Alloy Steels for Cold-Forming Using Cryogenic Treatment

Influence of Deep Cryogenic Treatment on Microstructures and Mechanical Properties of an Ultrafine-Grained WC-12Co Cemented Carbide

Effects of traditional heat treatment and a novel deep cryogenic treatment on microstructure and mechanical properties of low-carbon high-alloy martensitic bearing steel

Cryogenic Treatment of Tool Materials: A Review

Effect of Deep Cryogenic Treatment on Wear Behavior of Cold Work Tool Steel

Experimental Investigation on the Effect of Deep Cryogenic Treatment on 100Cr6 Bearing Steel

Effects of deep cryogenic treatment on the microstructure evolution, mechanical and thermal fatigue properties of H13 hot work die steel

Effects of deep cryogenic treatment on the microstructure and friction performance of M35 high-speed steel

Influence of cryogenic treatment on the wear characteristics of 100Cr6 bearing steel

Effect of multiple deep cryo-treating and tempering on microstructure and property evolution of high carbon bearing steel

Enhancing the Wear Resistance of 100Cr6 Bearing Steel Using Cryogenic Treatment

Experimental Investigation on the Effect of Deep Cryogenic Treatment on 100 Cr6 Bearing Steel

Effect of Deep Cryogenic Treatment on Microstructure and Wear Resistance of LC3530 Fe-Based Laser Cladding Coating