Abstract:If a floating drilling platform encounters sudden bad sea conditions during deepwater operation, it is necessary to disconnect the drilling riser and the floating platform in an emergency. A buoyancy can structure is required to be installed at the top of the riser to ensure that the disconnected drilling riser can stand alone without instability accidents. According to the main structural characteristics and environmental conditions of the freestanding riser and the buoyancy can at the top of the riser, the compressive buckling stability of deepwater drilling riser in freestanding mode under the condition of insufficient top tension is studied in this paper, and the main problem is simplified to the buckling problem of an equal section beam under uniformly distributed axial load and top concentrated force. Firstly, the elastic stability control equation of the riser is established according to the mechanical balance, geometry and constitutive relationship of the riser's micro-element, and the equation as well as the corresponding top and bottom boundary conditions are made dimensionless. Secondly, the elastic stability equation of the micro-bending riser is linearized, the power series solution is obtained according to the perturbation theory, and the influence of different parameters on linear buckling is analyzed. Finally, we convert the elastic stability equation with large deflection into a two-point boundary value problem of the first-order differential equation system under the boundary conditions and two other given conditions. The shooting method program of the two-point boundary value problem including the changes of the top concentrated load and the distributed axial load parameters is developed by using MATLAB, and the calculation analysis is carried out, which reveals the rules of the buckling load and buckling shape after the buckling. The research results of this paper can provide scientific basis and technical guidance for the structure and size design of drilling riser and buoyancy can.

Study on Controllable Prestress of the Block in the FDSO Bottom with the Supports Adjustment

CONTROLLABLE STRESS ANALYSIS AND DESIGN OF FLAT STEEL RIBBON WOUND PRESSURE VESSEL

Structural Response Analysis of FPSO under Pool Fire

Strength Check and Stress Test for Hoisting Mechanism of the 1300t Box-type Derrick Floating Crane

Optimal Prestress Investigation on Tensegrity Structures Using Artificial Fish Swarm Algorithm

Floating Non-Traditional Manufacture of Floating Drilling Storage and Offloading Units-Study on Modeling and Optimization Method for the Underwater Rotating Technology

Study on the Underwater Rotating Apparatus with Changeable Rotating Angle

Reversed tension characteristics in subsea mooring connectors for an FPSO SPM in shallow water

Safety Analysis and Experimental Research on the Key Structure of FPSO Pressure Vessel Under the Complex Sea States

New modeling method for finite element analysis of large oil storage tanks

Mechanical Analysis of Submarine Pipeline During Off-Bottom Towing Operation

Design and numerical simulation of the elastomeric support for the topside modules of an FPSO

Experimental study on the fatigue failure mechanism of key joints in deepwater semi-submersible platform structures

Cracking Mechanism and Simplified Design Method for Bottom Flange in Prestressed Concrete Box Girder Bridge

Ultimate strength analysis of stiffened plate variation on double bottom of Floating Production Storage Offloading (FPSO)

Research on Dynamic Accuracy Control Method of Gravity Centre of FDSO Based on Floating Non-traditional Manufacture

Structural Control of the Ultra-Large Semi-Submersible Floating Offshore Wind Turbine

Life Prediction Method of Large Oil Storage Tanks In-service Based on Foundation Settlement Monitor

The effect of new steep wave riser configurations on the stability of the suspension cluster manifold based on Orcaflex

Study on Methods of Restraining the Heave Amplitude of the Semi-submersible Platform

Research on stability of deepwater drilling riser system in freestanding mode