Abstract:Voluntary hand movements are usually impaired after a cerebral stroke, affecting millions of people per year worldwide. Recently, the use of hand exoskeletons for assistance and motor rehabilitation has become increasingly widespread. This study presents a novel hand exoskeleton, designed to be low cost, wearable, easily adaptable and suitable for home use. Most of the components of the exoskeleton are 3D printed, allowing for easy replication, customization and maintenance at a low cost. A strongly underactuated mechanical system allows one to synergically move the four fingers by means of a single actuator through a rigid transmission, while the thumb is kept in an adduction or abduction position. The exoskeleton’s ability to extend a typical hypertonic paretic hand of stroke patients was firstly tested using the SimScape Multibody simulation environment; this helped in the choice of a proper electric actuator. Force-myography was used instead of the standard electromyography to voluntarily control the exoskeleton with more simplicity. The user can activate the flexion/extension of the exoskeleton by a weak contraction of two antagonist muscles. A symmetrical master–slave motion strategy (i.e., the paretic hand motion is activated by the healthy hand) is also available for patients with severe muscle atrophy. An inexpensive microcontroller board was used to implement the electronic control of the exoskeleton and provide feedback to the user. The entire exoskeleton including batteries can be worn on the patient’s arm. The ability to provide a fluid and safe grip, like that of a healthy hand, was verified through kinematic analyses obtained by processing high-framerate videos. The trajectories described by the phalanges of the natural and the exoskeleton finger were compared by means of cross-correlation coefficients; a similarity of about 80% was found. The time required for both closing and opening of the hand exoskeleton was about 0.9 s. A rigid cylindric handlebar containing a load cell measured an average power grasp force of 94.61 N, enough to assist the user in performing most of the activities of daily living. The exoskeleton can be used as an aid and to promote motor function recovery during patient’s neurorehabilitation therapy.

Design of a Mechanical Exoskeleton System for Improving Hand-Gripping Force

Design and Characterization of a High-performance Wearable Robot Using Symmetric Conjugate Surface Joints

Design and experimental testing of a force-augmenting exoskeleton for the human hand

Design of A Hand Exoskeleton Rehabilitation Device

A Biomimetic Tendon-driven Soft Hand Exoskeleton for Finger Extension based on Musculoskeletal and Biomechanical Principles.

Mechanism Design and Performance Analysis of a Wearable Hand Rehabilitation Robot

Force and motion control of a tendon-driven hand exoskeleton actuated by shape memory alloys

Development of a Hand Exoskeleton System for Index Finger Rehabilitation

A hand exoskeleton using a multi-segment mechanism with two degrees-of-freedom for each finger

Mechanical Design and Feasibility of a Finger Exoskeleton to Support Finger Extension of Severely Affected Stroke Patients

Design and Development of a Hand Exoskeleton for Rehabilitation of Hand Injuries

Research on Exoskeleton Structure Design of Hand Function Rehabilitation Robot

Design and Prototyping of an Underactuated Hand Exoskeleton With Fingers Coupled by a Gear-Based Differential

Design of a 3D-Printed Hand Exoskeleton Based on Force-Myography Control for Assistance and Rehabilitation

Design and Characterization of a Rolling-Contact Involute Joint and Its Applications in Finger Exoskeletons

An Exoskeleton System For Hand Rehabilitation Based On Master-Slave Control

Control of Newly-Designed Wearable Robotic Hand Exoskeleton Based on Surface Electromyographic Signals

Design of Soft Exoskeleton Structure for Hand Rehabilitation Actuated by Shape Memory Alloy

Design of Rehabilitation Hand Exoskeleton System for Injured Fingers

Fusing Topology Optimization and Pseudo-Rigid-Body Method for the Development of a Finger Exoskeleton

An Exoskeleton System for Hand Rehabilitation Driven by Shape Memory Alloy