Evaluating the Effect of PCD & TialN Coated Carbide End Mill’s Rake Angle on Machinability of Titanium Alloy Ti-6Al-4V

Sarwar Ali Abbasi,Ping Fa Feng

DOI: https://doi.org/10.4028/www.scientific.net/amr.1025-1026.564

2014-01-01

Advanced Materials Research

Abstract:This study evaluates the machinability of titanium alloy, Ti6Al4V in terms of tool-chip interface temperature, cutting forces and tool stresses by varying rake angle of PCD insert and compares the results with TiAlN coated carbide inserted end mill using finite element numerical simulations. It has been found that tool rake angle has significant effect and behaves differently for different evaluation parameters and also shows different behavior for two different cutting material inserts. It reduces cutting forces with every positive angle geometry, about 50% reduction is observed for both cutting tool materials for a change in angle from-7° to 34°, but for tool-chip interface temperature, 15% reduction has been observed when angle is changed from-7° to 15° but it starts rising again when angle is increased to 34° for PCD insert, but for TiAlN coated carbide insert a continuous drop of about 20% has been observed. For tool stresses tool rake angle has different effect. The stresses remains almost unchanged when angle is changed from-7° to 15° but increased by almost 20% when angle is changed to 34° for both insert materials. Results also have shown that PCD insert due to its excellent thermal conductivity and strength at elevated temperatures dissipates most of the heat into the chip and has almost half temperature near the tool edge as compared to TiAlN coated carbide insert and thus can be used for machining of Ti6Al4V alloy at much higher cutting speeds than TiAlN coated carbide insert with positive rake angle geometries (around 15°).