Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Numerical Study of Laminar Flow and Convection Heat Transfer of Nanofluids Inside Circular Tube

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Numerical Research on Convective Heat Transfer and Resistance Characteristics of Turbulent Duct Flow Containing Nanorod-Based Nanofluids

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Friction Factor And Heat Transfer Of Nanofluids Containing Cylindrical Nanoparticles In Laminar Pipe Flow

Numerical Investigation of Nanofluid Convection Performance in the Fully Developed Flow Regime of the Pipe with Constant Wall Temperature

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

A Numerical Investigation of Transient Natural Convection Heat Transfer of Aqueous Nanofluids in A Horizontal Concentric Annulus

Numerical Simulation of Flow and Heat Transfer Characteristics of CuO-Water Nano Fluids in a Flat Tube

Pressure Drop and Heat Transfer of Nanofluid in Turbulent Pipe Flow Considering Particle Coagulation and Breakage

Experimental study on cooling performance of nanofluid flow in a horizontal circular tube

Numerical investigations of laminar heat transfer and flow performance of Al 2 O 3 –water nanofluids in a flat tube

Numerical investigation on forced convection in rectangular cross section micro-channels with nanofluids

Numerical investigation of nanofluid laminar forced convection heat transfer between two horizontal concentric cylinders in the presence of porous medium

Numerical Study Of Nanofluids Flow Characteristics Using Les-Lagrange Method And Molecular Dynamics Simulation

Numerical investigation of natural convection flow inside a square enclosure filled with different nanofluids by using two-phase Eulerian–Eulerian model: A new correlation for Nusselt number

Numerical Heat Transfer Enhancement Using Different Nanofluids Flow Through Venturi and Wavy Tubes

Numerical Study of Flow and Heat Transfer Characteristics for Al2O3 Nanofluid in a Double-Pipe Helical Coil Heat Exchanger

Numerical Analysis of Mixed Convective Heat Transfer from a Square Cylinder Utilizing Nanofluids with Multi-Phase Modelling Approach

Numerical Investigation into the Convective Heat Transfer of Tio2 Nanofluids Flowing Through A Straight Tube under the Laminar Flow Conditions

Numerical Investigation on the Turbulent Flow Characteristic of Nanofluids in A Horizontal Circular Tube