Abstract:Despite numerous studies focused on the hydrothermal (HT) synthesis of fly ash zeolites (FAZs), this method still has many limitations, the main of which is the low yield of zeolites. Hydrothermally synthesized zeolites are typically multiphase and exhibit low purity, which limits their applicability. Pure-phase zeolites have been primarily prepared from filtrates after alkaline mineralization of fly ashes, not directly in suspension. In addition, the published methodologies have not been tested in a wider set of samples, and thus their reproducibility is not confirmed. The aim of the study is to propose a reproducible methodology that overcomes the mentioned limitations. The influence of the Si/Al ratio (1.3:1–1:2), the type and concentration of the activator (2/4 M NaOH/KOH/LiOH), the reagent (30% LiCl), the duration (24–168 h), and the temperature (50–180 °C) of the synthesis phases were studied. The sequence of the synthesis phases was also optimized, depending on the type of heat transfer. The fly ashes were analyzed by wavelength-dispersive X-ray fluorescence (WD XRF), flame atomic absorption spectrometry (F-AAS), and X-ray diffraction (XRD). The energy intensity of the synthesis was reduced through the application of unique microwave digestion technology. Both microwave and combined (microwave and convection) syntheses were conducted. FAZs were identified and quantified by XRD analysis. This study presents a three-stage (TS) hydrothermal synthesis of pure-phase sodalite in suspension. Sodalite (>99 wt.%) was prepared from nine fly ashes under the following conditions: I. microwave phase: 120 °C, 150 min, solid-to-liquid ratio (S/L) 1:5, Si/Al ratio 1:1.5, and 4 M NaOH; II. convection phase: 120 °C, 24 h, S/L 1:40, and the addition of 30 mL of 30% LiCl; and III. crystallization: 70 °C for 24 h. The formation of rhombododecahedral sodalite crystals was confirmed by scanning electron microscope (SEM) images.

Convenient Hydrothermal Synthesis of Zeolite a from Potassium-Extracted Residue of Potassium Feldspar

Hydrothermal Synthesis of Zeolite A from K-feldspar and Its Crystallization Mechanism

Preparation of potassium sulfate and zeolite NaA from K-feldspar by a novel hydrothermal process

Simple and rapid synthesis of zeolite W from K‐feldspar via the improved hydrothermal method

Synthesis of High-Quality NaP1 Zeolite from Municipal Solid Waste Incineration Fly Ash by Microwave-Assisted Hydrothermal Method and Its Adsorption Capacity.

Hydrothermal Synthesis of K-ZSM-5 Molecular Sieve from Potassium Feldspar

Synthesis of Zeolite from Thermally Treated Sediment

Synthesis of Pure Na–X and Na–P Zeolite from Acid-Extracting Residues of CFB Fly Ash by a Single-Step Hydrothermal Method

Experimental Study on Synthesis of 13X Zeolite Molecular Sieve from Potassium Feldspar Powder by Hydrothermal Reaction

Zeolite a preparation from high alumina fly ash of china using alkali fusion and hydrothermal synthesis method

Preparation of Zeolite F As Slow Release Fertilizers from K‐Feldspar Powder

Hydrothermal extraction of potassium from potassic quartz syenite and preparation of aluminum hydroxide

Synthesis of zeolite Li-ABW from fly ash by fusion method

Hydrothermal processing on potassic syenite powder: Zeolite synthesis and potassium release kinetics

Synthesis and Influence Factors Study of 4A Molecular Sieve via Halloysite

Preparation of potassium sulfate from K-feldspar by hydrothermal alkaline method:reaction principle and process evaluation

Conventional Hydrothermal Synthesis of MFI Zeolite in Methanol Solution

Synthesis of Ultra-Fine NaA Zeolite by Low-Temperature Hydrothermal Treatment

Hydrothermal/Alkali Fusion Synthesis of Zeolite NaA and NaX from Pyrophyllite Mineral Clay

Microwave-Assisted Hydrothermal Synthesis of Pure-Phase Sodalite (>99 wt.%) in Suspension: Methodology Design and Verification

Conversion of Aluminosilicate Residue Generated from Lithium Extraction Process to NaX Zeolite