Abstract:Sequencing batch reactor (SBR) technology has become one of the commonly used treatment systems for municipal and industrial wastewater in the past decades. Cyclic activated sludge technology is one of the newly developed variations of SBR process. In this study, because the water quality situation of effluent under low-temperature and high-load conditions was unstable in Wang-hill Wastewater treatment plant, and the phenomena of exceeding discharge standard about ammonia-nitrogen (NH3-N) and total nitrogen (TN) were serious in winter, the different operation modes (operation cycle and aeration time) and control parameters were selected and optimized to improve nitrogen removal performance, respectively. The results indicated that the national first level B criteria of the effluent quality could be reached and the stable discharge could be achieved under the operation conditions of the C mode with 6 h per cycle [influent 2 h, aeration 2.5 h (aeration starting from 1.5 h after influent), settling 1 h, draw/idle 1 h], the average removal rates of chemical oxygen demand (CODcr), NH3-N, and TN in the reactor were 91.8, 75.6, and 62.9%, respectively. Furthermore, the dissolved oxygen (DO) level and mixed liquor suspended solids (MLSS) content in the aeration phase were both optimized on the basis of the preferred C mode. The best ranges of DO and MLSS concentration during the aeration phase as high as 2.0-3.0mg/L and 5,000-6,000mg/L are essential for the best nitrogen removal performance. The average removal rates of CODcr, NH3-N, and TN in the reactor were 90.3, 83.2, and 69.1%, respectively. Obviously, alternating operation mode combined with parameter optimization was the optimal nitrogen removal strategy for low-temperature and high-load wastewater. These data are of great practical significance for the scientific control and management of the wastewater treatment plant and for references of water engineering professionals.

Optimizing Control Strategy of Interactive Reactor with Simulation

Control Strategy of Shortcut Nitrification.

Research on Control Strategy of Internal-Loop Airlift Reactor for Shortcut Nitrification

Operation Strategy of Interactive Reactor for Low Carbon but High Nitrogen and Phosphorus-contained Municipal Wastewater Treatment

Mathematical Simulation of Feedforward Control for Nutrient Removal in Anaerobic-Anoxic-oxic Processes.

Mathematical simulation and experimental verification of a novel control strategy for a single stage PN/A (partial nitrification/Anammox) SBR (sequencing batch reactor)

Simulation and Optimization of A Full-Scale Carrousel Oxidation Ditch Plant for Municipal Wastewater Treatment

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

A novel model-based adaptive control strategy for step-feed SBRs dealing with influent fluctuation.

A simulation-based integrated approach to optimize the biological nutrient removal process in a full-scale wastewater treatment plant

Hybrid supervised hierarchical control of a biological wastewater treatment plant

Study on a Discrete-Time Dynamic Control Model to Enhance Nitrogen Removal with Fluctuation of Influent in Oxidation Ditches.

Modeling and simulation of an extended ASM2d model for the treatment of wastewater under different COD: N ratio

Optimization of biological nitrogen removal in full-scale municipal WWTPs using activated sludge model simulation

Simulation and Optimization of WWTP Based on Operation Decision Support System

Startup operation and process control of a two-stage sequencing batch reactor (TSSBR) for biological nitrogen removal via nitrite

Intelligent Control/Operational Strategies in WWTPs through an Integrated Q-Learning Algorithm with ASM2d-Guided Reward

Enhanced Nitrogen Removal under Low-Temperature and High-Load Conditions by Optimization of the Operating Modes and Control Parameters in the Cast System for Municipal Wastewater

Simultaneous Removal of Nitrogen, Phosphorus and COD in an Integrated OCO Reactor.

Determine the most effective process control parameters on activated sludge based on particle swarm optimisation algorithm (Case Study: South wastewater treatment plant of Tehran)

Optimal Design and Simulation for the Intelligent Control of Sewage Treatment Based on Multi-Objective Particle Swarm Optimization