Abstract:Nano-sized aluminum (Nano-Al) powders hold promise in enhancing the total energy of explosives and the metal acceleration ability at the same time. However, the near-detonation zone effects of reaction between Nano-Al with detonation products remain unclear. In this study, the overall reaction process of 170 nm Al with RDX explosive and its effect on detonation characteristics, detonation reaction zone, and the metal acceleration ability were comprehensively investigated through a variety of experiments such as the detonation velocity test, detonation pressure test, explosive/window interface velocity test and confined plate push test using high-resolution laser interferometry. Lithium fluoride (LiF), which has an inert behavior during the explosion, was used as a control to compare the contribution of the reaction of aluminum. A thermochemical approach that took into account the reactivity of aluminum and ensuing detonation products was adopted to calculate the additional energy release by afterburn. Combining the numerical simulations based on the calculated afterburn energy and experimental results, the parameters in the detonation equation of state describing the Nano-Al reaction characteristics were calibrated. This study found that when the 170 nm Al content is from 0% to 15%, every 5% increase of aluminum resulted in about a 1.3% decrease in detonation velocity. Manganin pressure gauge measurement showed no significant enhancement in detonation pressure. The detonation reaction time and reaction zone length of RDX/Al/wax/80/15/5 explosive is 64 ns and 0.47 mm, which is respectively 14% and 8% higher than that of RDX/wax/95/5 explosive (57 ns and 0.39 mm). Explosive/window interface velocity curves show that 170 nm Al mainly reacted with the RDX detonation products after the detonation front. For the recording time of about 10 μs throughout the plate push test duration, the maximum plate velocity and plate acceleration time accelerated by RDX/Al/wax/80/15/5 explosive is 12% and 2.9 μs higher than that of RDX/LiF/wax/80/15/5, respectively, indicating that the aluminum reaction energy significantly increased the metal acceleration time and ability of the explosive. Numerical simulations with JWLM explosive equation of state show that when the detonation products expanded to 2 times the initial volume, over 80% of the aluminum had reacted, implying very high reactivity. These results are significant in attaining a clear understanding of the reaction mechanism of Nano-Al in the development of aluminized explosives.

Influence of Aluminum Particle Size on Thermal Decomposition of RDX

Molecular dynamics study on the thermal decomposition of 1,3,5-trinitro-1,3,5-triazinane (RDX) catalyzed by aluminum nanoparticles with different contents

The influence of aluminum particle size and oxidizer morphology in RDX-based aluminized explosives on their ability to accelerate metals

Enhancing RDX Thermal Decomposition in Al@RDX Composites with Co Transition Metal Interfacial Layer

Influence of Particle Size of Aluminum Powder and Morphology of Oxidizer in Rdx Based Aluminized Explosive on the Ability of Accelerating Metal (I)

ReaxFF molecular dynamics simulations on thermal decomposition of RDX-based CMDB propellants

Reactive Molecular Dynamics Simulation of Thermal Decomposition for Nano-Aluminized Explosives

Shock Response of 1,3,5-Trinitroperhydro-1,3,5-triazine (RDX): the C-N Bond Scission Studied by Molecular Dynamics Simulations

Influence of Particle Size, Morphology and Size Distribution on the Safety and Thermal Decomposition Properties of RDX

Effects of nano-sized aluminum on detonation characteristics and metal acceleration for RDX-based aluminized explosive

Preparation of Nano-CoFe2 O4,Al/CoFe2 O4 and Their Effects on Thermal Decomposition Performance of RDX

Study on Thermal Properties and Sensitivities of Nano-RDX

Activation and reaction mechanism of nano‐aluminized explosives under shock wave

Mechanism Investigation for Remarkable Decreases in Sensitivities from Micron to Nano Nitroamine

On weak influence of aluminum powder size on its post-detonation reaction in different time scales

Research of detonation products of RDX/Al from the perspective of composition

Effect of Nano-Magnesium Hydride on the Thermal Decomposition Behaviors of Rdx

Preparation Of Metallic Amorphous Al/Ti Spherical Particles And Their Catalysis Effects On The Thermal Decomposition Of High Explosives

Preparation and Properties of RDX/Al/SiO2 Nano-composite Energetic Materials

Dependence of Particle Size and Size Distribution on Mechanical Sensitivity and Thermal Stability of Hexahydro-1, 3, 5-Trinitro-1, 3, 5-Triazine

Preparation, Mechanical Sensitivity and Thermal Decomposition Characteristics of RDX Nanoparticles