Preparation of Atomic Emission Detector Equipped with In-Tube Micro Plasma Torch and Detection of Sulfur and Phosphorus Organic Compounds by Gas Chromatography

Tatsuro Nakagama,Kensuke Shinohara,Shinji Ughiyama,Jun Tsunokawa,Hulie Zeng,Hizuru Nakajima,Katsumi Uchiyama
DOI: https://doi.org/10.2116/bunsekikagaku.62.199
2013-01-01
BUNSEKI KAGAKU
Abstract:An atomic emission detector (AED) equipped with an in-tube micro plasma torch (in-tube MPT) using helium radio-frequency plasma (RFP) was prepared for gas chromatography (GC). An in-tube MPT was prepared by inserting a platinum tubular electrode for ground (0.3 mm i.d., 0.5 mm o.d.) in that for high-voltage RF applications (0.8 mm i.d., 1.0 mm o.d.) at 0.5 mm depth. The head of an optical fiber was inserted and fixed in the electrode for high voltage, and the end was connected to a compact CCD spectrometer. The electrode for ground was connected to a quartz capillary for GC in order to introduce the mixture of the make-up gas, carrier gas and analyte vapors. The prepared AED was set on a conventional GC for measurement. When thioanisole was used as a sulfur compound for the GC-AED measurement, the detection limit of sulfur was estimated to be 4 pg s(-1) by a calculation. This calculation used the standard deviation (sigma) obtained by a blank measurement and the slope of the calibration curve (a) (D = 3.3 sigma/a) at a detection wavelength of 921.3 nm with an applied power of 2 W, applied frequency of 230 kHz and a flow rate of make-up gas of 14 mL min(-1). In the case of triethyl phosphate as a test phosphorus compound, when the detection wavelength, applied power and frequency, and the flow rate of the make-up gas were set at 253.4 nm, 3 W, 230 kHz and 12 mL min(-1), respectively, 22 pg s(-1) was obtained to be the detection limit for phosphorus by the same estimation method.
What problem does this paper attempt to address?