Abstract:This article focuses on evaporative falling film heat transfer through numerical simulations. A two-dimensional symmetric liquid film flowing outside a single horizontal tube was simulated using the open-source CFD software OpenFOAM. The Tanasawa model was employed to consider mass transfer at the liquid–vapour interface, and the isoAdvector VOF method was used for interface tracking. The simulations explored the impact of film flow rate, tube surface heat flux, and tube diameter on the liquid film thickness and surface heat transfer coefficient. Additionally, the critical heat flux and operational limits were considered. The results demonstrate the accurate reproduction of evaporative falling film heat transfer performance by the present model. The film thickness exhibits a similar profile to adiabatic and sensible falling film heat transfer but provides smaller values. Similarly, the evaporative heat transfer coefficient exhibits significantly higher values and a gentle peripheral variation. The influence of heat flux on evaporative falling film heat transfer is contingent on the film flow rate; it can either enhance or weaken the process. Notably, a larger tube diameter negatively affects heat transfer, suppressing the impact of heat flux, and also increases the risk of liquid film dryout. For a given film flow rate, the average heat transfer coefficient increases initially, reaches a maximum value, and then decreases as the wall heat flux is increased. The peak heat flux, termed critical heat flux, increases with film flow rate but decreases with tube diameter. An operational limit exists where the heat flux is lower than the critical heat flux and the film flow rate is higher than the critical film flow rate; under these conditions, evaporative falling film heat transfer operates in a fully wetting status.

Characterization of the Microscopic Mechanics in Falling Film Evaporation Outside a Horizontal Tube

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Microscopic Mechanisms of Heat Transfer in Horizontal-Tube Falling Film Evaporation

Numerical simulation of horizontal-tube falling film evaporation using VOF method

Numerical Study of Falling Film Thickness over Fully Wetted Horizontal Round Tube

Modelling of evaporative falling-film heat transfer over a horizontal tube

Numerical Investigation of the Falling Film Thickness and Heat Transfer Characteristics over Horizontal Round Tube

An Investigation on the Falling Film Thickness of Sheet Flow over a Completely Wetted Horizontal Round Tube Surface

Heat Transfer Characteristics of Falling Film Evaporation on Horizontal Tube Arrays

Numerical simulation of the behavior of falling films on horizontal plain tubes

Influential Analysis of Geometrical Parameters on Falling-Film Thickness and Distribution of Sheet Flow Outside Horizontal Tube

Numerical Study of Heat Transfer Characteristics of Horizontal-Tube Falling Film Evaporation Process Coupling Condensation Inside the Tube

Numerical Simulation of Double-Phase Coupled Heat Transfer Process of Horizontal-Tube Falling Film Evaporation

Experimental Study and Numerical Simulation on Falling Film Thickness Outside a Horizontal Tube

Numerical analysis on flow and heat transfer of a tube bundle in a horizontal-tube falling film evaporator

Velocity and temperature profiles in annular falling films outside vertical tube with counter-current gas flow

Parametric Distribution of the Condensation and Evaporation Processes in Horizontal Tube Falling Film Evaporator

A Comprehensive Numerical Study on the Subcooled Falling Film Heat Transfer on a Horizontal Smooth Tube

Experimental Study on the Heat Transfer Characteristics of an Evaporating Falling Film on a Horizontal Plain Tube

Numerical Investigation on Characteristics of Falling Film in Horizontal-Tube Falling Film Evaporator

The Analysis of the Fluxion and Heat Transfer in the Liquid Film During the Process of Horizontal Tube Falling Film