Abstract:It is well known that the electrochemical performance of spinel LiMn2O4 can be improved by Al doping. Herein, combining X-ray diffraction, Raman spectroscopy, X-ray photoelectron spectroscopy, and spherical aberration-corrected scanning transmission electron microscopy (Cs-STEM) with in situ electron-beam (E-beam) irradiation techniques, the influence of Al doping on the structural evolution and stability improvement of the LiMn2O4 cathode material is revealed. It is revealed that an appropriate concentration of Al3+ ions could dope into the spinel structure to form a more stable LiAlxMn2–xO4 phase framework, which can effectively stabilize the surface and bulk structure by inhibiting the dissolution of Mn ions during cycling. The optimized LiAl0.05Mn1.95O4 sample exhibits a superior capacity retention ratio of 80% after 1000 cycles at 10 C (1 C = 148 mA h g–1) in the voltage range of 3.0–4.5 V, which possesses an initial discharge capacity of 90.3 mA h g–1. Compared with the undoped LiMn2O4 sample, the Al-doped sample also shows superior rate performance, especially the capacity recovery performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c11315.Rietveld analysis, SEM images and elemental mapping of LiAlxMn2–xO4, corresponding FFT patterns of the HAADF images, variations and fitting curves between Z′ and ω–0.5 in LiMn2O4 and LiAl0.05Mn1.95O4, HAADF images and EDS quantitative results of LiMn2O4 and LiAl0.05Mn1.95O4 samples before and after 1000 cycles at 10 C, thickness distribution results by EELS measurements of LiMn2O4 and LiAl0.05Mn1.95O4 samples, and results obtained from the Rietveld analysis and XPS fitting parameters (PDF)This article has not yet been cited by other publications.

Electrochemical performance of Al 2 O 3 pre-coated spinel LiMn 2 O 4

Electrochemical performance of Al2O3 pre-coated spinelLiMn2O4

Electrochemical Performance of Spinel LiMn_2O_4 Modified

Electrochemical Studies on Al2O3-Coated Spinel LiMn2O4 for Lithium Ion Batteries

Synthesis and Electrochemical Performance of Al2O3 Coated LiNi0.03Co0.05Mn1.92O4 as Cathode Material

Enhanced electrochemical performances of 5 v spinel LiMn 1.58Ni0.42O4 cathode materials by coating with LiAlO2

Electrochemical Performance of Al_2O_3-coated LiMn_2O_4 Cathode Materials by Solid-state Reaction at Room Temperature

Synthesis and Characterization of Li_(1.035)Mn_(1.965)O_4 and Al-doped Li_(1.035)Al_(0.035)Mn_(1.930)O_4 as Cathode Materials for Li-ion Batteries by a Wet-chemical Technique

Understanding the Effect of Al Doping on the Electrochemical Performance Improvement of the LiMn 2 O 4 Cathode Material

Electrochemical performance of Al2O3-coated LiNi 1/3Co1/3Mn1/3O2 cathode materials for Li-ion batteries

Electrochemical Characterization of Surface-Modified LiMn 2 O 4 Cathode Materials for Li-ion Batteries

Performance of Li[Li0.2Mn0.54Co0.13Ni0.13] O2 Coated with Α-Lialo2

Electrochemical Performance of Al-Doped Spinel LiMn_2O_4 Cathode Material for Li-Ion Batteries

Investigation the Electrochemical Performance of Li1.2Ni0.2Mn0.6O2 Cathode Material with ZnAl2O4 Coating for Lithium Ion Batteries

High Electrochemical Stability Al-doped Spinel LiMn2O4 Cathode Material for Li-ion Batteries

Synthesis and Characterization of Li1.035mn1.965o4 and Al-Doped Li1.035al0.035mn1.930o4 As Cathode Materials for Li-Ion Batteries by A Wet-Chemical Technique

Understanding the Effect of Al Doping on the Electrochemical Performance Improvement of the LiMn2O4 Cathode Material.

Synthesis of Hollow Microspheres LiNi0.5Mn1.5O4 Coated With Al2O3 and Characterization of the Electrochemical Capabilities

Enhanced Electrochemical Performance of MoO3-coated LiMn2O4 Cathode for Rechargeable Lithium-Ion Batteries

Synthesis Modiifed Spinel LiMn2O4 Via Amorphous Li-Mn-Al-Co-O Precursor

Electrochemical Performance of Al<sub>2</sub>O<sub>3</sub>-Coated LiNi<sub>1/3</sub>Co<sub>1/3</sub>Mn<sub>1/3</sub>O<sub>2</sub> Cathode Materials for Li-Ion Batteries