Abstract:A simple, novel atomic emission spectrometer (AES) based method for the determination of trace iron ion in water sample was proposed by atmospheric pressure glow discharge (APGD) coupled with photochemical vapor generation (PVG). The Fe solution mixed with formic acid was going through an ultraviolet (UV) lamp to generate volatile specie of iron and then entering the APGD excitation source for excitation and detection with microspectrometer. Several working conditions were optimized to acquire best analytical performance such as argon flow rate, sample flow rate, concentration of formic acid, pH value, and discharge current. The increase of argon flow rate, sample flow rate, and pH value along with the Fe signal intensity was increasing to a maximum value and then decreasing with similar trend. The optimal values of the argon flow rate, the sample flow rate, and the pH value were 300 mL . min(-1), 2. 6 mL . min(-1), and 3.5, respectively. The Fe signal intensity increased with the increase of formic acid concentration from 10% to 50% (V/V) but the formic acid concentration with 40% (V/V) was selected when taking the stability of discharge into consideration. The Fe signal intensity decreased with the increase of discharge current from 10 to 35 mA. When the discharge current was below 10 mA, the plasma was unstable and easy to extinguish and the discharge current at 12 mA was selected. Under the optimal operating conditions, the detection limit (DL) for Fe (249. 8 nm) was 2.1 mu g . L-1 and the relative standard deviation (RSD) was 2. 5% (n=9) with the proposed PVG-APGD-AES. The interferences caused by a series of metal elements including Cd2+, Mg-2(+), Ca2+, Au+, Zn2+, Mn2+, K+, As5+, Al3+, Cr3+, Ni2+, and Cu2+ in determining Fe using PVG-APGD-AES method were examined separately and the recoveries were all in the range of 87. 6%similar to 107. 2%. The accuracy of the proposed method was validated by the determination of certified reference material (GSB 07-1188-2000) and the results agreed well with the certified value. The results suggested that the developed simple, robust, and cost-effective PVG-APGD-AES is promising for the determination of trace Fe in field.

Determination of Metallic Elements in Environmental Samples by Matrix-Assisted Microwave Induced Plasma Surface Sampling Atomic Emission Spectrometry

Matrix-Assisted Plasma Atomization Emission Spectrometry for Surface Sampling Elemental Analysis

In-situ Determination of Metallic Variation and Multi-Association in Single Particles by Combining Synchrotron Microprobe, Sequential Chemical Extraction and Multivariate Statistical Analysis.

Determination of Trace Ag, Au, Ge, Pb, Sn and Te by Microwave Plasma Torch Atomic Emission Spectrometry Coupled with an Electrothermal Vaporization Sample Introduction System.

Dispersive Liquid–Liquid Microextraction and Micro-Solid Phase Extraction for the Rapid Determination of Metals in Food and Environmental Waters

Method Development for Simultaneous Determination of Transition (Au, Ag, Cd, Cu, Mn, Ni, Pb, Zn) and Noble (Pd, Pt, Rh) Metal Volatile Species by Microwave-Induced Plasma Spectrometry Using Ultrasonic Micronebulizer Dual Capillary Sample Introduction System

On-line Electrolytic Dissolution of Alloys and Multi-Element Determination by Inductively Coupled Plasma Atomic Emission Spectrometry

Determination of Metals in Environmental Waters by Solution Cathode Glow Discharge -Atomic Emission Spectroscopy (SCGD-AES) with a Syringe Pump for Sample Introduction

Simultaneous determination of traces of Pt, Pd, Os, Ir, Rh, Ag and Au metals by magnetic SPE ICP OES and in situ chemical vapour generation

Determination of Micro Elements in Drinking Water by Using a Simultaneous MPT Spectrometer with a Flow Injection on-line Preconcentration System

Hollow-fiber Liquid-Phase Microextraction Prior to Low-Temperature Electrothermal Vaporization ICP-MS for Trace Element Analysis in Environmental and Biological Samples.

Direct Determination of Trace Elements in Micro Amounts of Biological Samples Using Electrothermal Vaporization Coupled to Icp-Aes

Determination and Distributed Characteristic Research on Metal Elements in PM_(2.5)

Determination of Silver and Cadmium by Microwave Induced Plasma Atomic Absorption Spectrometry with Electrothermal Vaporization Sample Introduction System

[Determination of Metal Elements in PM2. 5 by ICP-OES with Microwave Digestion].

Determination Of Cd, Pb And Sr By Microwave Plasma Torch Atomic Emission Spectrometry Using An Electrothermal Vaporization Sample Introduction System

Determination of Trace Fe in Water Sample by Atmospheric Pressure Glow Discharge Microplasma Coupled with Photochemical Vapor Generation

An easy and simple kilowatt-MPT-MS-based metal elements analysis method for rapid environmental water monitoring: An example from Poyang Lake of China

Electrothermal Vaporization for Sample Introduction in Microwave-Induced Plasma-Atomic Absorption Spectrometry

Determination of Ultra-Trace Concentrations of Elements by Means of On-Line Solid Sorbent Extraction Graphite Furnace Atomic Absorption Spectrometry

Simultaneous determination of noble metals (Rh, Pd, Ir, Pt, and Au) in environmental samples by nebulized film dielectric barrier discharge vapor generation coupled with inductively coupled plasma mass spectrometry