FDM-assisted OA-CEAS system for simultaneous measurements of temperature, CO 2 , and CO in flames
Xuan Wang,Wenjian Huang,Guangzhen Gao,Yubing Yang,Hui Yang,Tingdong Cai
DOI: https://doi.org/10.1016/j.fuel.2024.133782
IF: 7.4
2024-11-28
Fuel
Abstract:A system based on off-axis cavity enhanced absorption spectroscopy (OA-CEAS) integrated with frequency division multiplexing (FDM)-assisted wavelength modulation spectroscopy (WMS) was developed for simultaneous measurements of temperature, CO 2 , and CO in flames by employing two distributed feedback (DFB) diode lasers at 2.0 μm and 2.3 μm. An integrated cavity with an open-path configuration was made up of two cavity mirrors with a reflectivity of 99.8 %, and an effective optical absorption path length of approximately 5.2 m was achieved within a 6 cm diameter flame region. A CO 2 line pair at 4990.418 cm −1 and 4990.664 cm −1 , along with a CO line at 4300.699 cm −1 , were selected as the measurement targets. The system was initially calibrated in a heated static cell and subsequently tested in C 2 H 4 /air premixed flat flames for six different equivalence ratios. All concentrations measured by the 1 f -normalized 2 f signals were compared with the results obtained from both the direct absorption signals and simulations based on adiabatic chemical equilibrium calculations using Chemkin. Additionally, the measured temperatures were compared with the thermocouple readings. According to the measurements conducted at representative C 2 H 4 flames with different equivalence ratios, the accuracies for the measurements of temperature, CO 2 concentrations, and CO concentrations were ∼1.062 %, ∼1.082 %, and ∼1.052 %, respectively. All the measurements illustrate the potential of the system for combustion diagnosis.
energy & fuels,engineering, chemical