Abstract:Lithium-ion batteries have attracted attention with the development of electric vehicles and the introduction of renewable energy. For use in these applications, lithium-ion batteries with fast charge and discharge acceptability are particularly important. The charge and discharge reactions of lithium-ion batteries are limited by several factors such as ion and electron transfer in the electrode and electrolyte, charge transfer at the electrode-electrolyte interface, and reaction rates during phase transitions. It has been reported that the rate limiting factor of the biphasic materials is the phase boundary rearrangement, and the activation energy of such phase transition has been investigated in previous studies. However, there are variations in the reported activation energy values even for the same electrode material. Since there are many unexplored factors that affect the phase transition rate, we have examined the effect of these factors on the phase transition rate using LiFePO 4 as model electrodes. In our previous presentation, we showed that the phase transition behavior of LiFePO 4 electrode changes depending on the electrolyte, suggesting the influence of the electrode/electrolyte interface. (1) In this presentation, we report the relationship between the activation energy of the biphasic reaction and that of the solvation/desolvation of the electrolyte measured using a four-probe cell (2), and the effect on the phase transition behavior when the transferred ion species is changed from Li + to Na + . A non-aqueous-type three-electrode cell was composed of the LiFePO 4 as a working electrode, lithium foils as a counter and reference electrodes, and a 1 mol dm –3 solution of LiPF 6 in ethylene carbonate and diethyl carbonate (1:1 v/v) as an electrolyte solution and was constructed in an Ar-filled glove box. An aqueous-type three-electrode cell was composed of the LiFePO 4 as a working electrode, a Ni wire as a counter electrode, Ag/AgCl/sat’d KCl aq as a reference electrode, and a 0.5 mol dm –3 Li 2 SO 4 aqueous solution as an electrolyte solution. The charging–discharging behavior was firstly measured to confirm the cell characteristics and then the potential step measurement was employed. The Avrami plots based on the potential step results (3) were used to obtain the reaction rate constant k . Further experiments at different temperatures were performed and the Arrhenius plots were drawn to calculate the activation energy of the phase transition. (3) The activation energy for solvation/desolvation of the electrolyte was calculated by making a four-probe cell with the counter electrode and reference electrode symmetrically arranged across the solid electrolyte Li 2 OAl 2 O 3 SiO 2 P 2 O 5 TiO 2 (OHARA) and measuring AC impedance spectra at different temperatures. For the Na + system, the LiFePO 4 electrode was electrochemically delithiated to produce FePO 4 , and then Na + was inserted into FePO 4 to obtain NaFePO 4 in the aqueous electrolyte. Electrochemical measurements were performed with the obtained electrode. The potential step measurements were performed with the aqueous and non-aqueous electrolyte cells. Their activation energies were obtained from the Arrhenius plots with the k values and compared. The activation energy measured in the aqueous electrolytes was smaller than that measured in the nonaqueous electrolyte. The activation energy for the solvation/desolvation processes was also smaller for the aqueous electrolytes system, suggesting that the charge transfer process between electrode and electrolyte is involved in the rate-determining process of the phase transition. Next, we performed the same experiment by changing the mobile ion species from Li + to Na + . The activation energy for Na + extraction was nearly zero, suggesting very fast phase transition. If the volume change corresponding to the phase transition limits the rate, large Na + extraction would lead to high activation energy than Li + extraction. The tendency was the opposite, suggesting that the weak interaction of Na + and water affects the whole phase transition. References (1) C. Yamamoto, A. Ikezawa and H. Arai, The 242 nd Electrochemical Society Meeting, A02-0130 (2022). (2) Z. Ogumi., Electrochemistry , 78 , 319 (2010). (3) J. Allen, T.R. Jow, and J. Wolfenstine, Chem. Mater ., 19 , 2108-2011 (2007). (4) Y. Orikasa, T. Maeda, Y. Koyama, T. Minato, H. Murayama, K. Fukuda, H. Tanida, H. Arai, E. Matsubara, Y. Uchimoto, and Z. Ogumi, J. Electrochem. Soc . 160 , A3061-A3065 (2013). Figure 1

Suppressed Activation Energy For Interfacial Charge Transfer Of A Prussian Blue Analog Thin Film Electrode With Hydrated Ions (Li+, Na+, And Mg2+)

Impedance spectroscopic study on interfacial ion transfers in cyanide-bridged coordination polymer electrode with organic electrolyte

Weakly Solvating Effect Spawning Reliable Interfacial Chemistry for Aqueous Zn/Na Hybrid Batteries

Quantifying Interfacial Ion Transfer at Operating Potassium-Insertion Battery Electrodes within Highly Concentrated Aqueous Solutions

Fast-Charging Capability of Thin-Film Prussian Blue Analogue Electrodes for Aqueous Sodium-Ion Batteries

Operando Electrochemical X-ray Diffraction and Raman Spectroscopic Studies Revealing the Alkali-Metal Ion Intercalation Mechanism in Prussian Blue Analogues.

Probing the Electrode-Electrolyte Interface of a Model K-Ion Battery Electrode─The Origin of Rate Capability Discrepancy between Aqueous and Non-Aqueous Electrolytes.

Thermodynamic and Kinetic Analyses of Ion Intercalation/Deintercalation Using Different Temperatures on NiHCF Electrodes for Battery Electrode Deionization.

Insight into the Activation Energy for the Interfacial Stability Evaluation in All-Solid-state Li-ion Batteries

The Reduction of Interfacial Transfer Barrier of Li Ions Enabled by Inorganics-Rich Solid-Electrolyte Interphase

Aqueous/non-aqueous electrolyte tradeoffs in charge transfer and electrochromics of pseudocapacitive oxide films

Realizing Superior Prussian Blue Positive Electrode for Potassium Storage Via Ultrathin Nanosheet Assembly

Progress on Transition Metal Ions Dissolution Suppression Strategies in Prussian Blue Analogs for Aqueous Sodium-/Potassium-Ion Batteries

(Energy Technology Division Graduate Student Award sponsored by BioLogic) Probing and Engineering Electrode-Electrolyte Interfaces in Electrochemical Energy Storage and Conversion

Operando Hard X-Ray Photoelectron Spectroscopy for Observing Interfacial Electrochemical Reactions in All-Solid-State Batteries

Surface‐like diffusion of fast ions in framework energy materials for Li‐ and Na‐ion batteries

Phase Transition Behavior of Biphasic Systems Affected By the Charge-Transfer Process

Pre-intercalation chemistry of electrode materials in aqueous energy storage systems

A novel border-rich Prussian blue synthetized by inhibitor control as cathode for sodium ion batteries

Ionic transport kinetics of selective electrochemical lithium extraction from brines

Research Progress Towards Understanding the Unique Interfaces Between Concentrated Electrolytes and Electrodes for Energy Storage Applications