Abstract:The stability/instability behavior of polystyrene (PS) films with tunable thickness ranging from higher as-cast to lower residual made on Si substrates with and without native oxide layer was studied in this paper. For further extraction of residual PS thin film (hresi) and to investigate the polymer–substrate interaction, Guiselin’s method was used by decomposing the polymer thin films in different solvents. The solvents for removing loosely adsorbed chains and extracting the strongly adsorbed irreversible chains were selected based on their relative desorption energy difference with polymer. The PS thin films rinsed in chloroform with higher polarity than that of toluene showed a higher decrease in the residual film thickness but exhibited earlier growth of holes and dewetting in the film. The un-annealed samples with a higher oxide film thickness showed a higher decrease in the PS residual film thickness. The effective viscosity of PS thin films spin-coated on H-Si substrates increased because of more resistance to flow dynamics due to the stronger polymer–substrate interaction as compared to that of Si-SiOx substrates. By decreasing the film thickness, the overall effective mobility of the film increased and led to the decrease in the effective viscosity, with matching results of the film morphology from atomic force microscopy (AFM). The polymer film maintained low viscosity until a certain period of time, whereupon further annealing occurred, and the formation of holes in the film grew, which ultimately dewetted the film. The residual film decrement, growth of holes in the film, and dewetting of the polymer-confined thin film showed dependence on the effective viscosity, the strength of solvent used, and various involved interactions on the surface of substrates.

Autophobicity and Layering Behavior of Thin Liquid-Crystalline Polymer Films

Order in Thin Films of Side-Chain Liquid-Crystalline Polymers

Growth Of A Single-Domain Smectic Phase In A Thin Liquid-Crystalline Polymer Film

Dewetting of Polymer Films with Built-In Topographical Defects

Effect of film thickness on morphological evolution in dewetting and crystallization of polystyrene/poly(ε-caprolactone) blend films.

Dynamics and Structure Formation of Confined Polymer Thin Films Supported on Solid Substrates.

Dewetting of thin polymer films: Influence of interface evolution

Dewetting dynamics of sheared thin polymer films: an experimental study

Dewetting of Thin Polymer Films Reveals Non-Equilibrium Conformational Difference Between Substrate and Air Sides

Autophobic dewetting of a poly(methyl methacrylate) thin film on a silicon wafer treated in good solvent vapor.

Transient rheology and morphology in sheared nanolayer polymer films

Slippage and Nanorheology of Thin Liquid Polymer Films

Crystallization in the Thin and Ultrathin Films of Poly(Ethylene-Vinyl Acetate) and Linear Low-Density Polyethylene

Stable freestanding thin films of copolymer melts far from the glass transition

Effect of Crystallization on the Lamellar Orientation in Thin Films of Symmetric Poly(Styrene)-B-Poly(L-Lactide) Diblock Copolymer

Instability of Hydrophobic and Viscoelastic Polymer Thin Films in Water at Room Temperature.

Stability of Adsorbed Polystyrene Nanolayers on Silicon Substrates

An interfacial instability in a transient wetting layer leads to lateral phase separation in thin spin-cast polymer-blend films

Influence of bidisperse self-assembled monolayer structure on the slip boundary condition of thin polymer films

Effects of Copolymer Composition, Film Thickness, and Solvent Vapor Annealing Time on Dewetting of Ultrathin Block Copolymer Films.

Phase Separation Dynamics and Pattern Formation in Thin Films of A Liquid Crystalline Copolyester in Its Biphasic Region