Fabrication of Thermoelectric Devices Using Thermal Spray: Application to Vehicle Exhaust Systems

Jon P. Longtin,Lei Zuo,David Hwang,Gaosheng Fu,Mahder Tewolde,Yikai Chen,Sanjay Sampath

DOI: https://doi.org/10.1007/s11666-013-9903-1

IF: 2.839

2013-01-01

Journal of Thermal Spray Technology

Abstract:Thermoelectric devices produce electricity directly from heat; they are small, have no moving parts, and are quiet. Commercially available thermoelectric devices, however, are expensive and labor intensive to produce, and come in very limited form factors. This article presents initial results for the use of thermal spray to directly fabricate thermoelectric devices. The target application is automotive exhaust systems and other high-volume heat sources. In this work, FeSi 2 and Mg 2 Si metal silicides were sprayed. Characterization of the Mg 2 Si deposits indicates that both the thermal conductivity and the Seebeck coefficient are roughly one half the values of bulk Mg 2 Si. The electrical conductivity, however, is several orders of magnitude lower than bulk measurements in the literature, with likely reasons including impurities in the starting powder, oxidation during spraying, and using an undoped material. Fe x Co 4− x Sb 12 skutterudite material has also been sprayed; however, not enough powder was available to fabricate samples large enough for characterization. The steps required to fabricate a thermoelectric device are presented, including the formation of the bottom and top metallic layers and the thermoelectric legs using thermal spray and laser micromachining. A technique for bridging the air gap between adjacent thermoelectric elements for the top layer based on a sacrificial filler material has also been demonstrated.