Abstract:Plasma-wall interaction (PWI) is a critical concern in tokamaks because of its significant impact on the lifetimes of plasma-facing materials (PFMs), fuel retention, and plasma performance. In 2020, the Experimental Advanced Superconducting Tokamak (EAST) PFMs were upgraded to predominantly metallic walls. Following the 2021 experimental campaign, the deposition distribution and fuel retention on the surfaces of the PFMs along both the poloidal and toroidal directions were analyzed. The poloidal tests commenced at the high-field side (HFS), proceeded to the lower divertor, then to the low-field side (LFS), and finally to the upper divertor. The toroidal tests were performed at the midplane of the HFS, beginning from port A and ending at port P. The distributions of the deposits in the poloidal and toroidal directions were clearly asymmetrical. Mo and Fe particles sputtered from the first wall and inner stainless steel (SS) components were prone to deposition in the lower divertor region, as evidenced by the fact that the elemental content in the far-SOL region of the inner divertor exhibited Mo and Fe peaks, as did both the near- and far-SOL regions of the outer divertor. In addition, quick re-deposition of W and Fe was observed, as demonstrated by the fact that their contents near the erosion sources were higher than those farther away along the toroidal first wall on the HFS. This tendency was stronger for W than for Fe. Further analysis indicated that the deposits consisted of Li, C, O, W, Mo, Fe, Cu, and Ni. The Li and Fe contents were much higher than those of other metal impurities, with peak values of 8.17 μg/mm 2 and 7.78 μg/mm 2 , respectively. The Li content decreased along the HFS first wall from 8.17 μg/mm 2 at P-2 to 1.82 μg/mm 2 at P-22, and then increased to 2.72 μg/mm 2 at P-32 in the divertor, while the Fe content was higher around the top side and the midplane of the HFS. The deposited Li originated from routine wall conditioning and existed primarily in the form of Li 2 CO 3 . Additionally, other metal impurities deposited on the Li 2 CO 3 surfaces exhibited various irregular shapes, often appearing as aggregated and recrystallized small particles. Furthermore, significant deuterium (D) retention on the order of 10 21 atoms/m 2 was measured on all the analyzed SiC-coated graphite tiles on the HFS. The D content at location P-10 at the midplane was the highest along the poloidal direction of the HFS because it was directly facing the NBI beam.

Investigation Ofzeffand Impurity Behaviour in Lithium Coating Experiments with Full Metallic First Wall in HT-7 Tokamak

Impact of Impurity Mixture Gas Seeded by Supersonic Molecular Beam Injection on Edge-Localized Modes in the HL-2A Tokamak

Overview of Experimental Results on the HL-2A Tokamak

OV / 4-5 1 Overview of Experimental Results on the HL-2 A Tokamak

Overview of Hl-2a Experiment Results

Plasma performance enhancement and impurity control by novel technique of argon-hydrogen mixture fueled glow discharge wall conditioning in ADITYA-U tokamak

OV / 4-3 1 Overview of Experimental Results on HL-2 A

Enhancing Disproportionation Resistance of Zr2Co-based Alloys by Regulating the Binding Energy of H Atom

Investigation of Impurity Confinement in Lower Hybrid Wave Heated Plasma on EAST Tokamak

First observation of edge impurity behavior with n = 1 RMP application in EAST L-mode plasma

Post-mortem analysis of material deposition and fuel retention on the plasma-facing materials after the 2021 campaign in EAST

Tunable LiZn‐Intermetallic Coating Thickness on Lithium Metal and Its Effect on Morphology and Performance in Lithium Metal Batteries

Deuterium retention in co-deposition with lithium in Magnum-PSI: experimental analysis and comparison with SOLPS-ITER

I-mode plasma confinement improvement by real-time lithium injection and its classification on EAST Tokamak

Moderation of neoclassical impurity accumulation in high temperature plasmas of helical devices

Studies of material migration and deposition after the 2017 experimental campaign in EAST

Influence of hydrogen content in tokamak scrape-off-layer on performance of lithium divertor

Effects of Carbon Deposition on Deuterium Plasma-Driven Permeation Through Tungsten-Coated RAFM Steel

Enhancement of Tokamak Fusion Test Reactor Performance by Lithium Conditioning

Heavy impurity confinement in hybrid operation scenario plasmas with a rotating 1/1 continuous mode

Improved Confinement Mode Induced by the MARFE on the HT-7 Superconducting Tokamak