Abstract:The use of a polymer gel is an effective method for water shutoff in mature oilfield development. As for fractured reservoirs, in order to mitigate the filtration of gelant (fluid solution of cross-linker and polymer that exists before gelation) to matrix and increase the enduring erosion ability of mature gel, chromium(III) acetate, and phenol formaldehyde cross-linking, the HPAM gel system of a secondary cross-linking method is used more often. Chromium(III) salt is often used as the first cross-linker. However, the cross-linking mechanism is achieved by an ion bond, which is less stable than a covalent bond when used as an organic cross-linker. Resorcinol and phenol formaldehyde used as the first and secondary cross-linker, respectively, are discussed in this paper. Results showed that resorcinol can quickly cross-link with HPAM at room temperature. Gelant formulated with a combination of 0.3 wt % HPAM added to 10-30 mg/L resorcinol can increase its viscosity from 10.2 to 150 mPa . s within 2 h. SEM results show that the microstructure of the first cross-linking gel appears in typical dendritic shape, with branched chains diffused in arbitrary directions. The high shearing tolerant ability of the first cross-linking gel can be achieved by these branched chains. However, a tight 3-D network structure is formed in the microstructure of the secondary cross-linking gel. This is the benefit of the stability of the skeleton structure of gel enhancing. The main factors, including temperature and total dissolved solids (TDS), to affect the gelation performance of this secondary cross-linking gel are also discussed. Results show that gelation time decreased and gel strength increased with increasing temperature and TDS. Especially for TDS, the adverse law of the gelation performance with PEI/PAtBA or PEI/HPAM gel systems is shown. The gelation performance of a resorcinol/phenol-formaldehyde/HPAM gel system of a first cross-linking state after flowing through porous media is studied. Atomic force microscopy (AFM) scanning results show that in comparison to the original gel, the structure of the weak cross-linking (code B) gels has a certain degree of damage after flowing through porous media. However, the final gel strength of both gels do not show an apparent difference. This demonstrated that the first cross-linking achieved by resorcinol can guarantee the effectiveness of secondary cross-linking. This study suggests that a resorcinol/phenol-formaldehyde/HPAM secondary cross-linking gel system can be used for water shutoff in fractured reservoirs.

Gelation Performance and Microstructure Study of Chromium Gel and Phenolic Resin Gel in Bulk and Porous Media

Comparison of Gelation Behavior and Morphology of Resorcinol–Hexamethylenetetramine–HPAM Gel in Bulk and Porous Media

Study on dynamic gelation of hydrophobic associating polymer/Cr~(3+) gel in porous media

Plugging Mechanisms Of Polymer Gel Used For Hydraulic Fracture Water Shutoff

Investigation of In Situ Gelation Behavior and Enhanced Oil Recovery Ability of Polymer Gel Used for Controlling CO2 Channeling in Tight Fractured Reservoir

Study on Rheology and Microstructure of Phenolic Resin Cross-Linked Nonionic Polyacrylamide (NPAM) Gel for Profile Control and Water Shutoff Treatments

Development and Performance Evaluation of Delayed Cross-linking Chromium Gel

Leak-off Behavior and Water Shut-off Performance of a Polymer/chromium(cr 3+ ) Gel in Fractured Media

Dynamic gelation in porous media of phenol resin gel

Insights into the Key Aspects Influencing the Rheological Properties of Polymer Gel for Water Shutoff in Fractured Reservoirs

Novel Gel with Controllable Strength for In-Depth Conformance Control: Bulk Gelation Performance and Propagation Properties in Porous Media

The Use of Environmental Scanning Electron Microscopy for Imaging the Microstructure of Gels for Profile Control and Water Shutoff Treatments

The Effect of Shear Rate on Dynamic Gelation of Phenol Formaldehyde Resin Gel in Porous Media

Effect of Polymer and Crosslinker Concentration on Static and Dynamic Gelation Behavior of Phenolic Resin Hydrogel

Study on long-term stability of polymer gel system under reservoir conditions

Study on properties of phenolic resin gel applied in offshore oilfield

Improved Understanding Ultra-High Strength Gel for Sealing Operations: Gelation Kinetics and Mechanism

Experimental Investigation of the Novel Phenol−Formaldehyde Cross-Linking HPAM Gel System: Based on the Secondary Cross-Linking Method of Organic Cross-Linkers and Its Gelation Performance Study after Flowing Through Porous Media

Gelation Performance and Feasibility Study of an Environmental Friendly Improved Inorganic Aluminum Gel for Conformance Control Under Harsh Reservoir Conditions

Research and Microstructure Analysis of High Performance Gel

A Study on Influencing Factors of Gelation Behavior of HPAM-Complex Chromium Gel