Abstract:Numerical simulation was made of transient mass transfer to a surfactant contaminated buoyancy-driven drop controlled by appreciable resistance in both liquid phases. For this purpose, the momentum equations were formulated and solved in a boundary-fitted orthogonal coordinate system. On the basis of resolved hydrodynamics of the contaminated drop, the transient mass transfer was formulated and solved in the same coordinate system. In order to check the applicability of the numerical scheme, single drop extraction experiments were conducted in a totally closed droplet file column with the terminal effect efficiently eliminated. The MIBK–acetic acid–water system was used with small quantities of SDS (sodium dodecyl sulphate), Triton X-100, or Tween 80 introduced into the continuous phase. For these experimental cases, the flow field and the drag coefficient of a contaminated drop were simulated first. The numerical prediction of the drag coefficient is found in good agreement with the corresponding experimental data. It illustrates that the behavior of a drop approaches that of a rigid sphere and that about 100 times higher bulk concentration of SDS than that of Triton X-100 is required for the same extent contamination of a MIBK drop of the same size. Then the information of the flow field of a contaminated MIBK drop was used in simulating the transient mass transfer of solute into the drop. The resulted extraction fraction and overall mass transfer coefficient are in reasonable coincidence with the experimental data. Both numerical results and experimental data show that overall mass transfer coefficient of a heavily contaminated drop is only about one third of that in the pure system. This can be explained well by the distribution of the local Sherwood number, which drops down abruptly along the rear stagnant surface. Also the interfacial resistance of adsorbed surfactant was incorporated in the mass transfer model and then estimated by the least square fitting the simulation with data. The numerical results also show that Tween 80 presents obvious interfacial resistance on the acetic acid diffusing across the interface, whereas SDS and Triton X-100 show no interfacial resistance. It is suggested that the numerical simulation can be resorted in some solvent extraction systems containing surfactants to conduct numerical experiments and parametric study.

Effect of Surfactant Type on Interfacial Area and Liquid Mass Transfer for CO2 Absorption in a Bubble Column

Modeling of Mass Transfer Characteristics of Bubble Column Reactor with Surfactant Present

Effect of surfactant on dynamics and gas-liquid mass transfer for single carbon dioxide bubbles

Effects of surfactant contamination on oxygen mass transfer in fine bubble aeration process

A Mathematical Model for Single CO2 Bubble Motion with Mass Transfer and Surfactant Adsorption/desorption in Stagnant Surfactant Solutions

Gas–liquid Mass Transfer in the Presence of Ionic Surfactant: Effect of Counter‐ions and Interfacial Turbulence

Influence of a Second Liquid Phase upon Carbon Dioxide Chemical Absorption

Carbon Dioxide Capture in Sodium Carbonate Solution: Mass Transfer Kinetics and Dtac Surfactant Enhancement Mechanism

Enhanced Carbon Capture Through Incorporation of Surfactant Additives

Mass Transfer of SO2 Absorption with an Instantaneous Chemical Reaction in a Bubble Column

Brazilian Journal of Chemical Engineering MASS TRANSFER OF SO 2 ABSORPTION WITH AN INSTANTANEOUS CHEMICAL REACTION IN A BUBBLE COLUMN

Quantitative Study of Gas-Liquid Interface Adsorption Based on Theoretical Modeling and Molecular Dynamics Simulation

Experimental study of interfacial mass transfer from single CO2 bubbles ascending in stagnant water

Modeling Gas-Liquid Interfaces by Dissipative Particle Dynamics: Adsorption and Surface Tension of Cetyl Trimethyl Ammonium Bromide at the Air-Water Interface.

Bubble size distribution and specific bubble interfacial area in two–phase microstructured dense bubbling bed

Investigation of surfactant effect on ozone bubble motion and mass transfer characteristics

Effect of surfactant type and concentration on the gas-liquid mass transfer in biotrickling filters used for air pollution control

Effects of Interfacial Molar Ratios of Anionic/cationic Surfactant Mixtures on Properties at the Gas-Liquid Interface: a Molecular Dynamics Study

Micro-interface Enhanced Mass Transfer Sodium Carbonate Absorption Carbon Dioxide Reaction

Effects of surface-active agents on mass transfer of a solute into single buoyancy driven drops in solvent extraction systems

The Influence of Ultrasonic Radiation and Additives on Mass Transfer in Bubble Column