Abstract:This work used the in-situ synthesis of molten-state nitride ceramic phase-reinforced Ni-based alloy coatings, aiming to improve the phase-interface bonding through the interdependent co-solidification between molten droplets. The XRD was used to analyze the physical phases of the composite coatings. The microstructure and phase-interface structure were characterized in detail by combining SEM, TEM, HRTEM, FFT, and SAED techniques. Microhardness tester and microforce microhardness tester were employed to measure the surface hardness and elastic modulus of the composite coatings. The fracture behavior of the composite coatings was characterized by observing the fracture morphology of the coatings using SEM combined with the EDS technique. It was found that the formation mechanisms of interfacial misfit dislocation assistance, lattice distortion, aggregation of stacking faults, and specific growth orientation between the gamma -Ni matrix phase and each ceramic phase in NiCrBSi-TiCrN composite coatings improved the lattice matching between the two-phase interface, which resulted in the formation of atomically corresponding coherent lattice relations and stepped interfacial semi-coherent lattice relations, and enhanced the degree of phase-interface bonding. On this basis, the composite coatings with high Cr content further inhibited the expansion of interphase penetration cracks due to the existence of Cr-rich zones at the phase interface, thus exhibiting high fracture toughness. This work provides new opinions on the improvement of phase-interface bonding and composition design of Ni-based composite coatings. (c) 2024 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.

In-situ Control of Microstructures of Ceramic Composites.

In Situ Combustion Synthesis of Composite Ceramics

Issues in nanocomposite ceramic engineering: focus on processing and properties of alumina-based composites

In situ processing of electroceramic fine particles/polymer hybrids

Investigation on microstructure control of in-situ synthesized high-performance Cf/SiC composites

Characterization of the Interfacial Structure and Fracture Behavior of in Situ Synthesized Ceramics to Reinforce Ni-based Composite Coatings

In situ synthesis of hybrid and multiple-dimensioned titanium matrix composites

In Situ Preparation of (tib + TiC + Nd2O3)/Ti Composites by Powder Metallurgy

Inorganic/inorganic composites through emulsion templating

Obtaining Ultimate Functionalities in Nanocomposites: Design, Control, and Fabrication

Processing of in situ aluminum-matrix composites and controlling of the solidification microstructures

Increase of Specific Interfacial Coherence in Nanocrystalline Ceramic-Metal Composites

Controlling the Periodically Ordered Nanostructures in Ceramics: A Macromolecule-Guided Strategy.

Research Progress on the Control of Interfacial Reactions in Metal Matrix Composites

Ultrafine Grained Bulk Ceramic Composites Consolidated from Nanostructured Composite Powders by Pressure Less Sintering

Novel Procssing Of In-Situ Composites; Strengthening, Toughening And Crack Sensing

Processing of Functional Ceramics by Metallorganic Route

Reinforcing and Toughening Alumina/titania Ceramic Composites with Nano-Dopants from Nanostructured Composite Powders

Microstructure compatibility and its effect on the mechanical properties of the α-SiC/β-Si3N4 co-reinforced barium aluminosilicate glass ceramic matrix composites

Synthesis of Ceramic Nanocomposite Powders with in Situ Formation of Nanowires/Nanobelts

Exploring the sintering behavior of a complex ceramic powder system using in-situ X-ray nano-tomography