Abstract:Wearable devices have been widely used for the home monitoring of physical activities and healthcare conditions, among which ambulatory electrocardiogram (ECG) stands out for the diagnostic cardiovascular information it contains. Continuous and unobtrusive sensing often requires the integration of wearable sensors to existing devices such as watches, armband, headphones, etc.; nonetheless, it is difficult to detect high-quality ECG due to the nature of low signal amplitude at these areas. In this paper, a high-performance system with multi-channel signal superposition for weak ECG real-time detection is proposed. Firstly, theoretical analysis and simulation is performed to demonstrate the effectiveness of this system design. The detection system, including electrode array, acquisition board, and the application (APP), is then developed and the electrical characteristics are measured. A common mode rejection ratio (CMRR) of up to 100 dB and input inferred voltage noise below 1 μV are realized. Finally, the technique is implemented in form of ear-worn and armband devices, achieving an SNR over 20 dB. Results are also compared with the simultaneous recording of standard lead I ECG. The correlation between the heart rates derived from experimental and standard signals is higher than 0.99, showing the feasibility of the proposed technique.

A Design of A Combined-Lead ECG Monitoring System with Low-Power and WSN

Research of Wireless Electrocardiograph Signal Sampling System

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

Design and development of an ecg monitoring system based on wireless system-on-chip technology

A Novel Wearable ECG Monitoring System Based on Active-Cable and Intelligent Electrodes

Design of a Novel Portable ECG Monitor for Heart Health

An Active-Cable Connected ECG Monitoring System for Ubiquitous Healthcare

Design and Implementation of a Portable and Remote ECG monitoring System for CareON

ECG Monitoring System Based on Wireless Sensor Network and LabVIEW

A Smart Portable ECG Monitoring System with High Precision and Low Power Consumption.

A Low-Power, Wireless, Real-Time, Wearable Healthcare System

Design of the Athlete's Electrocardiogram Monitoring and Evaluation System Based on Wireless Sensor Network

A High-Performance System for Weak ECG Real-Time Detection

Real-Time Ecg Monitor-System Based On Embedded Ethernet Technique

Energy-Efficient Intelligent ECG Monitoring for Wearable Devices

Implementation of Wearable Terminal Used for Dynamic ECG Real-time Monitoring Based on Internet of Things

Design of Portable 12-Lead Digital ECG with Low Power Consumption

[An Ultra-Low Power, Wearable, Long-Term ECG Monitoring System with Mass Storage].

An Intelligent Atrial Fibrillation Wireless Monitoring System Based on Nonlinear Bind Source Extraction Algorithm

Design of Pre-processing Circuit for Wireless ECG Monitoring System

Design of a Wearable 12-Lead Noncontact Electrocardiogram Monitoring System