Abstract:In this study, one of the commonly used MXene (Ti3C2Tx) and β nucleated isotactic polypropylene (β-iPP)/MXene composites of different compositions were fabricated. The effects of MXene on non-isothermal crystallization and polymorphic behavior of β-iPP/MXene composites were comparatively studied. The non-isothermal crystallization kinetics indicates that for all samples, the lower cooling rates promote composites to crystallize at higher temperatures. When MXene and β-Nucleating agent (β-NA) are added separately, the crystallization temperature of composites shifts towards higher temperatures at all cooling rates. When MXene and β-NA are added simultaneously, the composite shows different cooling rate dependence, and the effects of improving crystallization temperatures is more obvious under rapid cooling. The activation energy of four samples iPP, iPP/MXene, iPP/β-NA, and iPP/MXene/β-NA were −167.5, −185.5, −233.8, and −218.1 kJ/mol respectively, which agree with the variation tendency of crystallization temperatures. The polymorphic behavior analysis obtained from Differential Scanning calorimetry (DSC) is affected by two factors: the ability to form β-crystals and the thermal stability of β-crystals. Because β-crystals tend to recrystallize to α-crystals below a critical temperature, to eliminate the effect of β-α recrystallization, the melting curves at end temperatures Tend = 50 °C and Tend = 100 °C are comparatively studied. The results show that more thermally unstable β-crystals would participate in β-α recrystallization with higher cooling rates. Moreover, thermal stability of β-crystals is improved by adding MXene. To further verify these findings, samples of three different thermal conditions were synthesized and analyzed by DSC, X-Ray Diffraction (XRD), and Polarized Light Optical Microscopy (PLOM), and the results were consistent with the above findings. New understandings of synthesizing β-iPP/MXene composites with adjustable morphologies and polymorphic behavior were proposed.

Properties and Crystallization Behaviors of Isotactic Polypropylene under Action of an Effective Nucleating Agent

Investigation on the Effects of MXene and Β-Nucleating Agent on the Crystallization Behavior of Isotactic Polypropylene

Effects of Bicyclic [2,2,1] Heptane Di-carboxylate on Properties, Crystallization, and Melting Behaviors of Isotactic Polypropylene

Nucleation Effects of A Novel Nucleating Agent Bicyclic [2,2,1] Heptane Di-Carboxylate in Isotactic Polypropylene

Exploring the Effects of MXene on Nonisothermal Crystallization and Melting Behavior of Β-Nucleated Isotactic Polypropylene

Nucleating agent for polypropylene comprising the calcium salt of 4‐methyl‐cyclohexane‐1,2‐dicarboxylic acid

Influence of compounded α/β-nucleating agents on the crystallization behavior and mechanical properties of isotactic polypropylene

Non-isothermal crystallization behavior of polypropylene with nucleating agents and nano-calcium carbonate

Effect Of Beta-Nucleating Agents On Crystallization And Melting Behavior Of Isotactic Polypropylene

Effect of nucleating agents on crystalline morphology and mechanical properties of polypropylene

Effects of nucleating agent content on the microstructure and macroscopic performances of polypropylene analyzed by non‐isothermal crystallization behaviors and isothermal crystallization morphologies

Synergistic toughening effects of elastomer toughener and nucleating agent on mechanical properties and crystallization behaviors of polypropylene

Crystallization, mechanical, and heat resistance performances of copolymer polypropylene modified by α nucleating agent

STUDY ON CRYSTALLIZATION BEHAVIOR OF ISOTACTIC POLYPROPYLENE PRODUCED BY SUPERCRITICAL POLYMERIZATION

The mechanical properties, crystallization and rheological behavior of isotactic polypropylene with nucleating agent supported on polyhedral oligomeric silsesquioxanes (POSS)

Synthesis and Effect Ofn,n'-Diphenylterephthalamide on Crystallization of Isotactic Polypropylene

Effect of the synergistic interaction of zinc adipate, hydrotalcite and ethylene propylene rubber on the performances of polypropylene

Effect of a novel compound nucleating agent calcium sulfate whisker/β-nucleating agent dicyclohexyl-terephthalamide on crystallization and melting behavior of isotactic polypropylene

Crystallization Behavior and Morphological Development of Isotactic Polypropylene with an Aryl Amide Derivative As Β-Form Nucleating Agent Part B Polymer Physics

Temperature‐dependent Selective Crystallization Behavior of Isotactic Polypropylene with a Β‐nucleating Agent

An effective nucleating agent for isotactic polypropylene (iPP): Zinc bis- (nadic anhydride) double-decker silsesquioxanes