Abstract:Intention, goal, scope, background: Advanced oxidation processes are powerful methods which are capable of transforming refractory, nonbiodegradable and/or toxic organic compounds into harmless end products such as carbon dioxide and water. However, one commen problem of all advanced oxidation processes is the high demand of electrical energy for ultraviolet lamps, which causes high operational costs. Minimization of the required irradiation time, and therefore the energy consumption, by optimization of other reaction conditions such as catalyst-oxidant type and concentration, pH, temperature, pollutant/oxidant ratio etc., therefore continues to gain importance. Objective: The main objective of this study was the minimization of the required irradiation time through optimization of the use of a newly patented catalyst, ferrioxalate, and also to compare the performance of this catalyst with the performance of other AOPs. Methods: Oxidation of 4-chlorophenol by photo-Fenton process using potassium ferrioxalate as a mediator was studied in a lab scale photoreactor. The influence of parameters such as hydrogen peroxide and ferrioxalate concentrations, initial pH, power-output, oxalate/iron ratio and different iron sources was evaluated. An upflow photoreactor equipped with a 1000 Watt high-pressure mercury vapour lamp and operating in a recirculation mode was used during photodegradation experiments. The extent of the reduction of 4-chlorophenol, Total Organic Carbon and Chemical Oxygen Demand was used to evaluate the photodegradation reaction. Results and discussion: The optimum pH range observed was found to be 2.7-3. The efficiency of 4-chlorophenol oxidation increased with increasing concentrations of hydrogen peroxide and ferrioxalate, reaching a plateau after the addition of 10 and 0.072 mM of those reagents, respectively. Using an Oxalate/iron ratio of 12 was 18% less efficient than using a ratio of 3:1. The efficiency increased with increasing radiation power. However, this increase was not linear. The UV/ferrioxalate/H2O2 process, by which complete mineralization of 100 mg l(-1) 4-chlorophenol was achieved in 20 min of total reaction time, was the most efficient process among the alternatives applied. Conclusions: The use of ferrioxalate as the catalyst was found to be more efficient than the use of Fe(II) and Fe(III) iron species. It was possible to completely mineralize 4-chlorophenol. Recommendation and outlook: The results of this study demonstrate that the ferrioxalate-mediated degradation of 4-chlorophenol requires less irradiation times than other advanced oxidation processes. There are mainly 19 phenol isomers and other toxic and nonbiodegradable organic compounds. We recommend that similar studies should be performed on many such compounds in order to attain a clear understanding of the performance of this catalyst. Because of its light sensitivity, this catalyst should be used immediately after its preparation. The use of low pressure mercury vapour lamps in this process should also be considered, since low power outputs may be enough for the process.

Photo-assisted Degradation of 2,4,5-Trichlorophenol by Electro-Fe(II)/Oxone® Process Using a Sacrificial Iron Anode: Performance Optimization and Reaction Mechanism

Degradation of 2,4,5-Trichlorophenoxyacetic Acid by a Novel Electro-Fe(II)/Oxone Process Using Iron Sheet As the Sacrificial Anode.

Photo-assisted Degradation of 2,4,5-Trichlorophenoxyacetic Acid by Fe(II)-catalyzed Activation of Oxone Process: the Role of UV Irradiation, Reaction Mechanism and Mineralization

2,4-Dichlorophenol Degradation by an Integrated Process: Photoelectrocatalytic Oxidation and E-Fenton Oxidation

Taping into the Super Power and Magic Appeal of Ultrasound Coupled with EDTA on Degradation of 2,4,6-TCP by Fe0 Based Advanced Oxidation Processes.

Ferrioxalate-mediated photodegradation and mineralization of 4-chlorophenol

Heterogeneous Electro-Fenton Using Modified Iron-Carbon As Catalyst for 2,4-Dichlorophenol Degradation: Influence Factors, Mechanism and Degradation Pathway

Comparison treatment of various chlorophenols by electro-Fenton method: Relationship between chlorine content and degradation

Enhanced degradation of 2,4-dichlorophenol by ultrasound in a new Fenton like system (Fe/EDTA) at ambient circumstance

Efficient Degradation of Tetracycline: Performance and Mechanism Study of Fe3o4@Cf Composite Electrode Materials Applied to a Non-Homogeneous Photo-Electro-Fenton Process

Photocatalytic Degradation of 2,4-Dichlorophenol Using Nanoscale Fe/TiO2

Electrochemical activation of peroxymonosulfate with titanium suboxide anode for 4-chlorophenol degradation: Influencing factors, kinetics, and degradation mechanism

Degradation of various chlorophenols by electrochemical, electro-fenton, microwave assisted photolytic and microwave assisted photocatalytic methods

Degradation of 2,4,6-Trichlorophenol Using Magnetic Nanoscaled Fe3O4/CeO2 Composite As a Heterogeneous Fenton-like Catalyst

Degradation of 4-Chlorophenol Solution by Synergetic Effect of Dual-frequency Ultrasound with Fenton Reagent

Degradation Efficiency of 4-Chlorophenol Via Heterogeneous Photo-Fenton

The Research on Electrochemical Oxidation Degradation of 2,4,6-trichlorophenol by Ti/IrO2-RuO2 Coating Electrode

Oxalate-assisted Oxidative Degradation of 4-Chlorophenol in a Bimetallic, Zero-Valent Iron–aluminum/air/water System

Oxidative degradation of p-chlorophenol by ferrate(VI): Kinetics, intermediates and pathways

Hybrid electro-Fenton and peroxi-coagulation process for high removal of 2,4-dichlorophenoxiacetic acid with low iron sludge generation

Enhanced Degradation of 2,4-Dichlorophenoxyacetic Acid by Electro-Fenton in Flow-Through System Using B, Co-TNT Anode