Abstract:Low-cost mesoporous silicas of the SBA-15 family were prepared, aimed for removal of a broad spectrum of both cationic and anionic forms of hazardous metal pollutants (Cr(III, VI), Mn(II, VII), Pb(II), Cd(II), and Cu(II)) from environmental water. Series of mono- and bifunctional materials with immobilized ethylenediaminetriacetic acid (EDTA), primary amine (NH), and quaternary ammonium (QAS) groups were prepared in a cost-efficient one-step synthesis using two silica sources, low-cost sodium metasilicate (NaSiO 9HO) and the conventional source-tetraethylorthosilicate (TEOS). The functionalized SBA-15 samples obtained from both silica sources were highly ordered, as evidenced by TEM and SAXS data. All obtained materials were mesoporous with high surface area values of up to 745 m/g, pore volumes from 0.99 to 1.44 cm/g, and narrow pore distributions near 7 nm. The adsorption affinity of the EDTA-functionalized samples followed the common order Pb(II)> Cd(II)> Cu(II)> Cr(III)> Mn(II), which could be explained based on the Pearson theory. The highest adsorption capacities were observed for samples functionalized by EDTA groups using TEOS for synthesis (TEOS/EDTA): 195.6 mg/g for Pb(II), 111.2 mg/g for Cd(II), 58.7 mg/g for Cu(II), 57.7 mg/g for Cr(III), and 49.4 mg/g for Mn(II). Moreover, organic matter (humic acid up to 10 mg/L) and inorganic (Na(I), K(I), Mg(II), Ca(II), etc) macrocomponents present in environmental water had almost negligible effect on the removal of these cations. The NaSi/EDTA/NH sample revealed a better selectivity compared to the NaSiNH sample towards such species as Cr(III), Mn(II), Cd(II), and Cu(II). The chromate-ions uptake at pH 7.5 by the TEOS/QAS sample turned practically unaffected by the presence of doubly charged anions (CO , SO ). The content of functional groups on the surface of MS decreased only slightly (∼1-5%) after several regeneration cycles. The complete desorption of all heavy metal ions can be achieved using 1 mol/L EDTA solution. Reusability tests demonstrated the complete stability of the adsorbent for at least five to six consecutive adsorption/desorption cycles with no decrease in its adsorption characteristics compared to those obtained by 0.05 mol/L HNO treatments. The synthesized mesoporous materials were evaluated for removal of the heavy metal ions from drinking and different natural water samples, proving their potential as sustainable, effective, and cost-efficient adsorbents.

Efficient Simultaneous Removal of Cu(II) and Cr2O72− from Aqueous Solution by a Renewable Amphoteric Functionalized Mesoporous Silica

Mesoporous Na+-SiO2 Spheres for Efficient Removal of Cr3+ from Aqueous Solution

Synthesis of functionalized mesoporous silica and its application for Cu(II) removal

Phosphoramidic acid functionalized silica microspheres for simultaneous removal of Cr(VI), As(V) and Se(VI) from aqueous solutions based on molecular geometry match

Synthesis of thiol-functionalized MCM-41 mesoporous silicas and its application in Cu(II), Pb(II), Ag(I), and Cr(III) removal

Concentration-dependant selective removal of Cr(III), Pb(II) and Zn(II) from aqueous mixtures using 5-methyl-2-thiophenecarboxaldehyde Schiff base-immobilised SBA-15

Adsorption Efficiency, Thermodynamics, and Kinetics of Amino-Functionalized Mesoporous Calcium Silicate for the Removal of Heavy Metal Ions

Synthesis of pyridyl Schiff base functionalized SBA-15 mesoporous silica for the removal of Cu(II) and Pb(II) from aqueous solution

Efficient removal of Cr(III) from wastewater by photo-responsive mesoporous silica

Bi-functionalized MCM-41 for heavy metal ions removal: synthesis, enhanced performance and mechanism study

Synthesis of cubic mesoporous silica SBA16 functionalized with carboxylic acid in a one-pot process for efficient removal of wastewater containing Cu 2+ : Adsorption Isotherms, Kinetics, and Thermodynamics

Removal behavior and mechanism of amino/carboxylate-functionalized Fe@SiO2 for Cr(VI) and Cd(II) from aqueous solutions

The simultaneous removal of co-contaminants pyrene and Cu (II) from aqueous solutions by Fe/Mn bimetallic functionalized mesoporous silica

Efficient removal of Cu(II), Pb(II), Cr(VI) and As(V) from aqueous solution using an aminated resin prepared by surface-initiated atom transfer radical polymerization

In situ Functionalized Mesoporous Silicas for Sustainable Remediation Strategies in Removal of Inorganic Pollutants from Contaminated Environmental Water.

Preparation of Amino-Fe(iii) Functionalized Mesoporous Silica for Synergistic Adsorption of Tetracycline and Copper.

Highly efficient nano-Fe/Cu bimetal-loaded mesoporous silica Fe/Cu-MCM-41 for the removal of Cr(VI): Kinetics, mechanism and performance

Selective removal of Cu(II) ions by magnetic mesoporous silica with surface ion-imprinted quaternized Schiff base coating

Green and simple synthesis of poly (catechol-tetraethylenepentamine)@aminopropyl-modified silica composite for removing toxic Cr(VI)

Bi-layered hollow amphoteric composites: Rational construction and ultra-efficient sorption performance for anionic Cr(VI) and cationic Cu(II) ions

Synergistic adsorption of As(V) from aqueous solution onto mesoporous silica decorated orderly with Al2O3 and Fe2O3 nanoparticles