Abstract:Purpose The purpose of this paper is to discuss the asymptotic models of different parts with a pitting fault in rolling bearings. Design/methodology/approach For rolling bearings with a pitting fault, the displacement deviation between raceways and rolling elements is usually considered to vary instantaneously. However, the deviation should change gradually. Based on this shortcoming, the variation rule and calculation method of the displacement deviation are explored. Asymptotic models of different parts with a pitting fault are discussed, respectively. Besides, rolling bearing systems have prominent fractional characteristics unconsidered in the traditional models. Therefore, fractional calculus is introduced into the modeling of rolling bearings. New dynamic asymptotic models of different parts with a pitting fault are proposed based on fractional damping. The numerical simulation is performed based on the proposed model, and the dynamic characteristics are analyzed through the bifurcation diagrams, trajectory diagrams and frequency spectrograms. Findings Compared with the model based on integral calculus, the proposed model can better reflect the periodic characteristics and fault characteristics of rolling bearings. Finally, the proposed model is verified by the experiment. The dynamic characteristics of rolling bearings at different rotating speeds are analyzed. The experimental results are consistent with the simulation results. Therefore, the proposed model is effective. Originality/value (1) The above models are idealized, i.e. the local pitting fault is treated as a rectangle. When a component comes into contact with the fault, the displacement deviation between the component and the fault component immediately releases if the component enters the fault area and restores if the component leaves. However, the displacement deviation should change gradually. Only when the component touches the fault bottom, the displacement deviation reaches the maximum. (2) Due to the material's memory and fluid viscoelasticity, rolling bearing systems exhibit significant fractional characteristics. However, the above models are all proposed based on integral calculus. Integral calculus has some local characteristics and is not suitable for describing historical dependent processes. Fractional calculus can better describe the essential characteristics of the system.

A New Model for the Relationship Between Vibration Characteristics Caused by the Time-Varying Contact Stiffness of a Deep Groove Ball Bearing and Defect Sizes

Model for dynamic characteristics produced by inner race local defect in ball bearing system and its simulation

Behaviour of an Angular Contact Ball Bearing with Three-Dimensional Cubic-Like Defect: A Comprehensive Non-Linear Dynamic Model for Predicting Vibration Response

Dynamic modeling considering time-varying contact pairs and parameterized defects of deep groove ball bearings for its vibration characteristic analysis

Dynamic modeling and vibration analysis of double row cylindrical roller bearings with irregular-shaped defects

Modeling of a deep-groove ball bearing with waviness defects in planar multibody system

Dynamic Analysis of Double-Row Self-Aligning Ball Bearings Due to Applied Loads, Internal Clearance, Surface Waviness and Number of Balls

The Effect of Fit Clearance between Outer Race and Housing on Vibration Characteristics of a Cylindrical Roller Bearing with Localized Defects

Dynamic Modeling and Simulation of Inter-Shaft Bearings with Localized Defects Excited by Time-Varying Displacement

Multiple-degree-of-freedom dynamic model of rolling bearing with a localized surface defect

Dynamic Behavior Analysis of a Rotor-Bearing-Squeeze Film Damper Coupling System with Bearing Outer Race Localized Defect

Dynamic characteristics of high-speed angular contact ball bearings considering the coupling of outer race waviness and local defects

Effect of clearance on the dynamic characteristics of high-speed rolling bearings with multiple defects

Asperity interaction induced vibration excitation of cylindrical roller bearings with localized defect

A Coupling Model of High-Speed Train-Axle Box Bearing and the Vibration Characteristics of Bearing with Defects under Wheel Rail Excitation

A Model-Based Local Fault Size Measurement Method of Rolling Bearing Considering Load Influence.

Mechanism and Method for Outer Raceway Defect Localization of Ball Bearings

A Simulation Investigation on the Influence of Bearing Outer Ring Defect on Dynamic Vibration Characteristics of the Axle‐Box System

Contact characteristic and vibration mechanism of rolling element bearing in the process of fault evolution

Dynamic Asymptotic Model of Rolling Bearings with a Pitting Fault Based on Fractional Damping

Dynamic simulation of a cylindrical roller bearing with a local defect by combining finite element and lumped parameter models