Abstract:This study was aimed to prepare the whey protein isolate(WPI) – sodium tripolyphosphate(STPP) aggregates using heating at higher pH value and evaluate their characteristics. The results of single-factor experiment showed that the increase of viscosity of polymers was different from the increasing of WPI concentration, temperature, p H value, STPP content and aggregation time. The models were obtained by using a Box-Behnken optimization experiment design with the 4 factors(temperature, p H value, STPP content and aggregation time) based on the results of single-factor experiments. The results of Box-Behnken optimization experiment showed that the order of the effect of the 4 factors on viscosity was as follows: temperature > STPP content > p H value > aggregation time. The optimized condition determined was that 10%(w/w) WPI, 0.09%(w/w) STPP at 90°C for 42 min with p H value of 8.40, and the actual viscosity was 5083 mP a·s. The prepared WPI-STPP thermal aggregates were the thick sample with a semi flow state, and the regression model was fitted well. Determination of properties and structural analysis of WPI, WPI-STPP thermal aggregates and WPI aggregates showed the water holding capacity, surface hydrophobicity and rheological characteristics of WPI-STPP thermal aggregates were improved compared with WPI and WPI aggregates. For WPI aggregates, water holding capacity increased from 4.83 to 5.20 g per gram protein(P<0.05). However, the solubility of WPI-STPP thermal aggregates decreased from 88.5% to 34.50%, which was lower than that of WPI. Heat treatment and STPP significantly affected the surface hydrophobicity of the soluble aggregates. WPI-STPP thermal aggregates could form good cold-induced gels, which could widen its application in foods of gel type. When STPP was added, the average particle size of whey protein thermally polymerized increased from 31.39±1.81 μm for WPI to 292.09±2.17 μm for WPI-STPP thermal aggregates. The difference between strong and weak soluble gels could be assessed by the oscillatory dynamic experiments using parallel-plate geometries. Rotational rheometer showed that the rheological characteristics of WPI-STPP thermal aggregates were improved. The rheological characteristics were determined from storage and loss moduli as the functions of time and frequency. WPI-STPP thermal aggregates had higher storage modulus values. The results showed that the increasing of particles played a significant role in the water holding capacity and rheological properties of these dispersions. The microscopic structure analysis of WPI-STPP thermal aggregates showed that they denatured fully, and the larger irregular fractal aggregates of WPI-STPP thermal aggregates could be most useful to increase the viscosity. Transmission electron microscopy showed that heat-induced WPI-Na Cl soluble gels had a dense structure and a higher number of cross-links. The utilization of WPI-STPP thermal aggregates is very attractive due to the low-complexity processing conditions needed, lower production cost and higher nutritive value. The production cost of yogurt is less than yogurt with pectin according to the optimal technological condition of the experiment. The application of this technology proposed in this paper will bring great economic benefits for the yogurt processing industry.

Thermal Aggregation Properties of Whey Protein Glycated with Various Saccharides

Glycation of whey protein to provide steric hindrance against thermal aggregation.

High Temperature-Short Time Glycation to Improve Heat Stability of Whey Protein and Reduce Color Formation

Heat stability improvement of whey protein isolate via glycation with maltodextrin without control of the relative humidity

Dispersible and thermal stable nanofibrils derived from glycated whey protein.

IMPROVED HEAT STABILITY OF WHEY PROTEIN ISOLATE BY GLYCATION WITH INULIN

Study on the rheological properties of heat-induced whey protein isolate-dextran conjugate gel

Investigating the thermal stability and calcium resistance of O/W emulsions prepared with glycosylated whey protein hydrolysates modified by different saccharides

Heat-induced aggregation of whey proteins in aqueous solutions below their isoelectric point

Effects of Ph and Different Sugars on the Structures and Emulsification Properties of Whey Protein Isolate-Sugar Conjugates

Preparation and characters of whey protein isolate-sodium tripolyphosphate aggregates by heating

An Insight into Heat-Induced Gelation of Whey Protein Isolate–lactose Mixed and Conjugate Solutions: Rheological Behavior, Microstructure, and Molecular Forces

Characterization of Whey Protein Isolate Aggregation Induced by Different Acidic Substances: Triggered by Disulfide Bond Formation and Recombination

Pickering emulsions stabilized by amphiphilic anisotropic nanofibrils of glycated whey proteins

Effects of thermal treatment on the formation and properties of whey protein isolate/whey protein hydrolysate-sodium hyaluronate complexes

Systematical Characterization of Physiochemical and Rheological Properties of Thermal-Induced Polymerized Whey Protein.

Heat-induced Gel Formation by Whey Protein Isolate-Deacetylated Konjac Glucomannan at Varying Ph Conditions

Regulation on Aggregation Behavior and in Vitro Digestibility of Phytic Acid–Whey Protein Isolate Complexes: Effects of Heating, Ph and Phytic Acid Levels

Structure and Property Changes of Whey Protein Isolate in Response to the Chemical Modification Mediated by Horseradish Peroxidase, Glucose Oxidase and D-Glucose.