Abstract:Residual lipids (RL) in whey protein isolate (WPI) are detrimental to optimal functional applications (e.g., foaming and low turbidity) and contribute to off-flavor development during powder storage. The objective of this research was to prepare an experimental WPI by removing RL without using the traditional microfiltration process and compare its properties with commercially available WPI made using microfiltration and some other whey powders. We hypothesize that by adjusting the pH of whey to <5.0, we would be close to the isoelectric point of any remaining denatured proteins (DP) and phospholipoproteins (PLP), and therefore reduce electrostatic repulsion between these molecules. Furthermore, demineralization of the acidified whey protein solution by UF combined with diafiltration (DF) should reduce ionic hindrance to aggregation and thereby help with the aggregation of these DP as well as most RL; centrifugation or clarification could be used to remove these materials. Calcium should also be more extensively removed by this approach, which should improve the heat stability of the experimental WPI. Demineralization was achieved on a pilot scale by acidifying liquid (cheese) whey protein concentrate containing 34% protein (WPC-34) to pH 4.5 using HCl, and UF of the whey protein solution along with extensive DF using acidified (pH ∼3.5) reverse osmosis filtered water. Demineralized whey protein solution was adjusted to various combinations of pH (4.1-4.9), conductivities (500-2,000 μS/cm), and protein concentrations (1%-7%) and then centrifuged at 10,000 × g for 10 min. The effective sedimentation (precipitation) of RL in these treatments was estimated by measuring the turbidity of the supernatants. Maximum precipitation was observed at pH 4.5 to 4.7. Reducing conductivity via UF/DF increased the precipitation of RL due to reduced ionic hindrance to aggregation. Maximum sedimentation of RL was observed at protein concentrations ≤3% because of a higher density difference between the precipitate and serum phase. Analysis by sodium dodecyl sulfate polyacrylamide gel electrophoresis analysis confirmed the sedimentation of phospholipoproteins, caseins, and DP upon isoelectric precipitation at pH ∼4.5, while native whey proteins or undenatured whey proteins remained soluble in the supernatant, unaffected by the pretreatment. To scale up the process, 750 L of fluid WPC-34 was acidified and demineralized by UF (volume concentration factor = 1.35) and DF until the permeate solids reached 0.1% (when desired demineralization was achieved), clarified using a pilot-scale desludging clarifier to remove RL, neutralized, ultrafiltered to concentrate the protein, and then spray-dried to produce an experimental WPI (91% protein and 1.8% fat on a dry basis [db]). In another trial, demineralized UF concentrate was clarified by gravity sedimentation and the supernatant was neutralized, ultrafiltered, and spray-dried to produce a second experimental WPI (91% protein and <1% fat db). These experimental WPI powders were compared with several commercially available WPI powders to assess functional properties such as solubility, heat stability, foamability and foam strength, gelation, and sensory attributes over accelerated storage. Experimental WPI had excellent functional properties, had low turbidity, were highly heat stable, and only developed very slight-to-slight off-flavors upon accelerated storage, and their properties were comparable to the WPI manufactured commercially using microfiltration even after accelerated storage.

Heat stability improvement of whey protein isolate via glycation with maltodextrin without control of the relative humidity

Study on potential antigenicity and functional properties of whey protein treated by high hydrostatic pressure based on structural analysis

Study on the rheological properties of heat-induced whey protein isolate-dextran conjugate gel

Heat-induced aggregation of whey proteins in aqueous solutions below their isoelectric point

Heat treatment as a food-grade strategy to increase the stability of whey protein particles under food system relevant conditions

Effects of thermal treatment on the formation and properties of whey protein isolate/whey protein hydrolysate-sodium hyaluronate complexes

Whey protein-polysaccharide conjugates obtained via dry heat treatment to improve the heat stability of whey protein stabilized emulsions

Heat-stable whey protein isolate made using isoelectric precipitation and clarification

Dry heat induced whey protein–lactose conjugates largely improve the heat stability of O/W emulsions

Effect of Maillard reaction conditions on the gelation and thermal stability of whey protein isolate/d-tagatose conjugates

Structure and physiochemical characteristics of whey protein isolate conjugated with xylose through Maillard reaction at different degrees

Investigating the thermal stability and calcium resistance of O/W emulsions prepared with glycosylated whey protein hydrolysates modified by different saccharides

Exploring the effects of whey protein components on the interaction and stability of cyanidin-3-O-glucoside

Stability of Whey Proteins during Thermal Processing: A Review

Preheat-stabilized pea proteins with anti-aggregation properties

Formation of whey protein isolate–dextran conjugates by Maillard reaction with ethanol-water pretreatment

Synergistic effect of microfluidization and transglutaminase cross-linking on the structural and oil-water interface functional properties of whey protein concentrate for improving the thermal stability of nanoemulsions

Whey Protein Isolate-Gum Acacia Maillard Conjugates As Emulsifiers for Nutraceutical Emulsions: Impact of Glycation Methods on Physicochemical Stability and in Vitro Bioaccessibility of Β-Carotene Emulsions.

Hygroscopic properties of whey protein hydrolysates and their effects on water retention in pork patties during repeated freeze–thaw cycles

Heat-induced changes in the ultrasonic properties of whey proteins

Modulating the texture of heat-set gels of phosphorylated walnut protein isolates through Glucono-δ-lactone acidification