Abstract:The two-conveyor-electrodes tribo-aero-electrostatic separator patented in 2010 was designed to sort granular mixtures of insulating materials in a fluidized bed subjected to an electric field perpendicular to the direction of the fluidizing air. The prototype ≤has proven its efficiency for the separation of insulating granules ≤ 2 mm, attaining excellent recovery rates. Its performances were less satisfactory for larger particles (2 to 4.5 mm). The objective of this work is to evaluate three modifications of the construction of this device, in order to increase the hourly throughput and improve the purity of the products, by controlling the charge acquired by the granules and the electric field intensity. Numerical simulations enabled the optimization of the electric field distribution in the active zone of the separator and an experimental study was carried out in order to identify the best conditions for granule charging by triboelectric effect. The tests were carried out for four configurations of the electrode system, by using a mixture of acrylonitrile butadiene styrene (ABS) and high impact polystyrene (HIPS) originated from grinding out-of-use computer cases. The typical granule size was 2 to 4.5 mm. The experimental approach validated a change in the position of the fluidized bed with respect to the conveyor electrodes, to increase the residence time of the granular materials and hence the amount of electric charge acquired by each particle. In order to intensify the electrical field, two solutions were tested and validated: (1) add a grounding electrode in the proximity of the high-voltage electrodes; (2) dispose vertically the high voltage electrodes. For the tested materials, the vertical arrangement of the electrodes gave the best hourly throughput rates and purity of the separated products.

Experimental Investigation of Electrostatic Charge Generation for Granules

A Mesh-Scale Monte Carlo Method for Modeling Triboelectric Charging of Chemically Identical Particles

Experimental Investigation of Electrostatic Reduction in a Gas–Solid Fluidized Bed by an in Situ Corona Charge Eliminator

Electrostatic Potentials in Gas–solid Fluidized Beds Influenced by the Injection of Charge Inducing Agents

Electrostatic potential in gas-solids fluidized beds influenced by injection of charge inducing agents

Physical Model of Granule Adhesion to the Belt-Electrodes of a Tribo-Aero-electrostatic Separator

Dynamic Densification of Wet Granular Materials in Continuous Dense Flows under Gravity

Contact Electrification Polarity of Polyethylene Particles: A Morphology-Derived Anomalous Size Dependence

Numerical modeling of the trajectories of plastic granules in a tribo-aero-electrostatic separator

Effect of polymer granules on the electrostatic behavior in gas-solid fluidized beds

Numerical analysis of frictional charging and electrostatic interaction of particles

Effect of humidity on triboelectric charging in a vertically vibrated granular bed: Experiments and modeling

Double origin of stochastic granular tribocharging

Probing static discharge of polymer surfaces with nanoscale resolution

Experimental investigation of a modified triboelectric charging device

Tribocharging of granular materials flowing in grounded inclined tubes

Tribo-charging properties of waste plastic granules in process of tribo-electrostatic separation

Improved Overall Performances of a Tribo-Aero-Electrostatic Separator for Granular Plastics from Waste Electric and Electronic Equipment

Experimental investigation of granular friction behaviors during reciprocating sliding

Experimental study of humidity influence on triboelectric charging of particle-laden duct flows

Analysis of the Dynamic Characteristics of XLPE Pellet Space Charge