Abstract:The dynamics of the transported powder determines the functionality and safety of pneumatic conveying systems. The relation between the carrier gas flow, induced by the flown-through geometry, and the powder flow pattern is not clear yet for electrostatically charged particles. This paper highlights the influence of relatively minor cross-sectional secondary flows and electrostatic forces on the concentration and dynamics of the particles. To this end, direct numerical simulations (DNS) capture the interaction of the continuous and dispersed phases by a four-way coupled Eulerian-Lagrangian strategy. The transport of weakly charged particles in channel flows, where turbopheresis defines the particle concentration, is compared to duct flows, where additional cross-sectional vortices form. For both geometries the Stokes number ($S\!t=8, 32$) and the electrical Stokes number ($S\!t_\mathrm{el}=[0, 1, 2, 4]\times 10^{-3}$) are varied, the turbulent carrier flow was fixed to $Re_\tau=360$. The presented simulations demonstrate that secondary flows, for the same $Re_\tau$, $S\!t$, and $S\!t_\mathrm{el}$, dampen the effect of particle charge. In a duct flow, vortical secondary flows enhance the cross-sectional particle mobility against the direction of electrostatic forces. Compared to a duct flow, in a channel the wall-normal aerodynamic forces are weaker. Thus, electrical forces dominate their transport; the local particle concentration at the walls increases. Further, electrostatic charges cause a stronger correlation between the gas and particle velocities. In conclusion, despite being weak compared to the primary flow forces, secondary flow and electrostatic forces drive particle dynamics during pneumatic transport.

Experimental study of humidity influence on triboelectric charging of particle-laden duct flows

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

A Mesh-Scale Monte Carlo Method for Modeling Triboelectric Charging of Chemically Identical Particles

Experimental Investigation of Electrostatic Reduction in a Gas–Solid Fluidized Bed by an in Situ Corona Charge Eliminator

Monitoring of Particle Motions in Gas-Solid Fluidized Beds by Electrostatic Sensors

Polarity switch of PMMA powder transported through a PMMA duct

Simulation of PMMA powder flow electrification using a new charging model based on single-particle experiments

Modeling and Analysis of Particle Triboelectrification in Pneumatic Conveying

Influence of weak electrostatic charges and secondary flows on pneumatic powder transport

Effect of humidity on triboelectric charging in a vertically vibrated granular bed: Experiments and modeling

Electric charge effect of micro-droplets generated by electrospray atomization on removal of indoor fine particulate matter

Theoretical Modeling of Relative Humidity on Contact Electrification of Sand Particles

Experiments on Enhancing the Particle Charging Performance of an Electrostatic Precipitator

Spatially resolved measurement of the electrostatic charge of turbulent powder flows

The effect of particle size and relative humidity on triboelectric charge saturation

Effect of Ambient Air Relative Humidity on the Surface Electric Potential Decay of Tribocharged Polypropylene and Polyvinyl Chloride Slabs

Atmospheric Humidity and Particle Charging State on Agglomeration of Aerosol Particles

Kinematic Characteristics and Thermophoretic Deposition of Inhalable Particles in Temperature Gradient Field

A Comparative Study On The Influence Of Particle Size On The Turbulence Characteristics Within Gas-Solids Pneumatic Flows Using An Electrostatic Sensor And Cfd-Dem Coupled Simulation

ELECTROSTATIC EFFECTS IN PNEUMATIC TRANSPORT OF GRANULAR MATERIALS