Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

Discrete Element Modeling of Rock Materials with Dilated Polyhedral Elements

Discrete Element Modeling of Polyhedral Representation of Granular Materials

Three‐dimensional Discrete Element Simulation for Granular Materials

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

3-D Numerical Modelling of Mesoscopic Configuration and Cracking of Concrete

Discrete Element Modelling of a Soil-Rock Mixture Used in an Embankment Dam

A new discrete element model for rock-like materials

DEM Simulation of Shearing Rockfills along Different Stress Paths

Investigation of Modeling Non-Spherical Particles by Using Spherical Discrete Element Model with Rolling Friction

Three dimensional distinct element numerical model for static and dynamic analysis of rock bodies

Simulation of rock fracture process based on GPU-accelerated discrete element method

A deformable spheropolygon-based discrete element method

Discrete Element Modeling of Strength and Failure Behavior of Transversely Isotropic Rock under Uniaxial Compression

Study on the Particle Breakage of Ballast Based on a GPU Accelerated Discrete Element Method

Bonded particle model for dilated polyhedron considering fracture modes and its application to lateral resistance of ballast bed in cold regions

A New Modified Replacement Method for Discrete Element Modelling of Rockfill Material

Hybrid Lattice-discrete element method for ballast modeling

Simulation of the Nonlinear Mechanical Behaviors of Jointed Rock Masses Based on the Improved Discontinuous Deformation and Displacement Method

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Three-dimensional deformable distinct element method with polyhedral elements and cloud GPGPU acceleration

Application of Distinct Element Method in Dynamic Analysis of High Rock Slopes and Blocky Structures