Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

Rapid Reservoir Storage–Based Benefit Calculations

Balancing social, economic and ecological benefits of reservoir operation during the flood season: A case study of the Three Gorges Project, China

Assessing the floodwater utilization potential in a reservoir-controlled watershed: A novel method considering engineering regulations and an empirical case from China

Comparative Analysis and Risk Assessment of Dam-Break Floods: Taking Pingshuijiang Reservoir As an Example

Enhancing Flood Risk Assessment and Mitigation Through Numerical Modeling: A Case Study

A GIS Based Model for Calculating of Flood Area

A new calculating method of staged limited water level and design flood using time series law of flood statistical characteristics within the year

Study of Ecological Storage Based on Optimization Simulation Technique

Optimal allocation of flood prevention storage and dynamic operation of water levels to increase cascade reservoir hydropower generation

Risk Analysis of Dynamic Water Level Setting of Reservoir in Flood Season Based on Multi-index

Evaluating Functions of Reservoirs′ Storage Capacities and Locations on Daily Peak Attenuation for Ganjiang River Basin Using Xinanjiang Model

Floodwater utilization potential assessment of China based on improved conceptual model and multi-reservoir basin assessment method

Estimating Sediment Trap Efficiency of Flood Events During Flood Season in the Three Gorges Reservoir

Integrated modelling of flow-sediment transport and power generation in the Three Gorges Reservoir

Dynamic Storage of Three Gorges Reservoir and Its Application to Flood Regulations: 1.sensitivity in Regulation

Multi-Objective Optimal Scheduling Model of Dynamic Control of Flood Limit Water Level for Cascade Reservoirs

Knowledge-Based Approach for Reservoir System Optimization

Economic Benefit Analysis of Joint Operation of Cascaded Reservoirs

Study on Reservoir Operation Model Based on Ecological Flow Calculation

Research on Water Level Control Scheme of Reservoir Flood Resources Utilization Considering Dam Safety and Risk Benefit

Risk analysis of reservoir floodwater utilization coupling meteorological and hydrological uncertainties