Abstract:Atomization spray of non-Newtonian liquid plays a pivotal role in various engineering applications, especially for the energy utilization. To operate spray systems efficiently and well understand the effects of liquid rheological properties on the whole spray process, a comprehensive model using Euler-Lagrangian approaches was established to simulate the evolution of the atomization spray for viscoelastic liquid. Based on the Oldroyd model, the viscoelastic linear dispersion relation was introduced into the primary atomization; an extended viscoelastic version of Taylor analogy breakup (TAB) model was proposed; and the coalescence criteria was modified by rheological parameters, such as the relaxation time, the retardation time and the zero shear viscosity. The predicted results are validated with experimental data varying air-liquid mass flow ratio (ALR). Then, numerical calculations are conducted to investigate the characteristics of viscoelastic liquid atomization process. Results showed that the evolutionary trend of droplet mean diameter, Weber number and Ohnesorge number of viscoelastic liquids along with axial direction were qualitatively similar to that of Newtonian liquid. However, the mean size of polymer solution increased more gently than that of water at the downstream of the spray, which was beneficial to stable control of the desirable size in the applications. As concerned the effects of liquid physical properties, the surface tension played an important role in the primary atomization, which indicated the benefit of selecting the solvents with lower surface tension for finer atomization effects, while, for the evolution of atomization spray, larger relaxation time and zero shear viscosity increased droplet Sauter mean diameter (SMD) significantly. The zero shear viscosity was effective throughout the jet region, while the effect of relaxation time became weaken at the downstream of the spray field.

Numerical Simulation of Water Spray Caused by a Rolling Airplane Tire

A numerical simulation of wheel spray for simplified vehicle model based on discrete phase method

Numerical Simulation of the Collision Behaviors of Binary Unequal-Sized Droplets at High Weber Number

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

An improved SPH scheme for the 3D FEI (Fluid-Elastomer Interaction) problem of aircraft tire spray

Numerical Simulation of Spray in Crossflow of Liquid Jet into Air Stream

Thin liquid film flow and heat transfer under spray impingement

Numerical Models For Viscoelastic Liquid Atomization Spray

Numerical simulations of spray jet in supersonic crossflows using an Eulerian approach with an SMD model

Spray Trajectory and 3D Droplets Distribution of Liquid Jet in Crossflow with Digital Inline Holography

Numerical Investigation of Film Formation Characteristics and Mechanisms through Airless Spraying on Spherical Surfaces

Three-Dimensional Simulation Of Effervescent Atomization Spray

Numerical Simulation of Water Film Flow and Breakup on Anti-Icing Surface

Effect of Aircraft Tire Wear on Water Spray and Water Displacement Drag

Numerical Simulation of Droplet Impact Onto Liquid Films with Smoothed Particle Hydrodynamics

Numerical Simulation of Water Droplets on Rough Surfaces

Numerical analysis and validation of spray distributions disturbed by quad-rotor drone wake at different flight speeds

Numerical Investigation of the Flow Dynamics and Evaporative Cooling of Water Droplets Impinging Onto Heated Surfaces: an Effective Approach to Identify Spray Cooling Mechanisms

Numerical simulation analysis of symmetric impact of two droplets on a liquid film

Numerical Study of Droplet Fragmentation During Impact on Mesh Screens

Numerical simulation for spray spatial distribution of swirl nozzle and its target dustfall area prediction