Abstract:The thermocatalytic hydrogenation of carbon dioxide (CO2) to methanol is considered as a potential route for green hydrogen storage as well as a mean for utilizing captured CO2, owing to the many established applications of methanol. Copper–zinc bimetallic catalysts supported on a zirconium-based UiO-66 metal–organic framework (MOF) were prepared via slurry phase impregnation and benchmarked against the promoted, co-precipitated, conventional ternary CuO/ZnO/Al2O3 (CZA) catalyst for the thermocatalytic hydrogenation of CO2 to methanol. A decrease in crystallinity and specific surface area of the UiO-66 support was observed using X-ray diffraction and N2-sorption isotherms, whereas hydrogen-temperature-programmed reduction and X-ray photoelectron spectroscopy revealed the presence of copper active sites after impregnation and thermal activation. Other characterisation techniques such as scanning electron microscopy, transmission electron microscopy, and thermogravimetric analysis were employed to assess the physicochemical properties of the resulting catalysts. The UiO-66 (Zr) MOF-supported catalyst exhibited a good CO2 conversion of 27 and 16% selectivity towards methanol, whereas the magnesium-promoted CZA catalyst had a CO2 conversion of 31% and methanol selectivity of 24%. The prepared catalysts performed similarly to a CZA commercial catalyst which exhibited a CO2 conversion and methanol selectivity of 30 and 15%. The study demonstrates the prospective use of Cu-Zn bimetallic catalysts supported on MOFs for direct CO2 hydrogenation to produce green methanol.

Catalytic Reduction of Carbon Dioxide into Methanol over Copper under Hydrothermal Conditions

CO2 Hydrogenation to Methanol over Cu/ZnO Catalysts Synthesized Via a Facile Solid-Phase Grinding Process Using Oxalic Acid

Methanol Production by Reduction of Formic Acid over Cu Catalyst under Hydrothermal Conditions

Theoretical Investigation on the CO2 Hydrogenation to Methanol Mechanism at Electron-Rich Active Interface over Cu/Ga-Ti-Al-O Catalyst

Hydrothermal Conversion of CO<sub>2</sub> into Formic Acid with Zinc and Copper Powders under Low Temperature

Effect of Cu and Zn on the performance of Cu-Mn-Zn/ZrO2 catalysts for CO2 hydrogenation to methanol

CO2 Hydrogenation to Methanol over Cu/ZnO/ZrO2 Catalysts Prepared Via a Route of Solid-State Reaction

Copper-doped ZnO-ZrO2 solid solution catalysts for promoting methanol synthesis from CO2 hydrogenation

CO2Hydrogenation over Copper/ZnO Single‐Atom Catalysts: Water‐Promoted Transient Synthesis of Methanol

Development of highly stable catalyst for methanol synthesis from carbon dioxide

Thermocatalytic Hydrogenation of CO2 to Methanol Using Cu-ZnO Bimetallic Catalysts Supported on Metal–Organic Frameworks

Reduction of formic acid to methanol under hydrothermal conditions in the presence of Cu and Zn.

Methanol Synthesis from CO2 Hydrogenation with a Cu/Zn/Al/Zr Fibrous Catalyst

Dual-site Activation of H2 over Cu/ZnAl2O4 Boosting CO2 Hydrogenation to Methanol

The Role of Cu1–O3 Species in Single-Atom Cu/ZrO2 Catalyst for CO2 Hydrogenation

Effect of hydrothermal environment on Cu-ZnO/Al2O3 catalyst for hydrogenation of CO2 to methanol

Catalytic Hydrothermal Conversion of Dissolved Carbon Dioxide into Methane

Low-Temperature Methanol Synthesis Catalyzed Over Cu/Gamma-Al2o3-Tio2 For Co2 Hydrogenation

Synthesis of a Cu@ZnO1-x/Al2O3 Catalyst with High-Density ZnO1-x-Cu Interfacial Sites for Enhanced CO2 Hydrogenation to Methanol

The unique interplay between copper and zinc during catalytic carbon dioxide hydrogenation to methanol

Effect of the nature of copper species on methanol synthesis from CO2 hydrogenation reaction over CuO/Ce0.4Zr0.6O2 catalyst