Abstract:The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.

Spots on Electrodes and Images of A Gap During Pulsed Discharges in an Inhomogeneous Electric Field at Elevated Pressures of Air, Nitrogen and Argon

Anode and Cathode Spots in High-Voltage Nanosecond-Pulse Discharge Initiated by Runaway Electrons in Air

Nanosecond Repetitively Pulsed Discharge of Point–Plane Gaps in Air at Atmospheric Pressure

Images of Pulsed Glow Discharge in Air at Different Pressures

Formation of diffuse and spark discharges between two needle electrodes with the scattering of particles

Pulsed Nanosecond Breakdown Of A Hollow Cathode Discharge With Pseudospark Geometry

Effect of Pulse Rise Time on the Glow Discharge in Nonuniform Electric Field

Diffuse and Filamentary Discharges in Open Air Driven by Repetitive High-Voltage Nanosecond Pulses

Coaxial Diffuse Discharges Driven by Repetitive Nanosecond Pulses at Different Air Pressures

Breakdown, Discharge Modes, and Gaseous Recovery of Atmospheric Air with Repetitive 10 Ns Pulses

Experimental study of atmospheric pressure single-pulse nanosecond discharge in pin-to-pin configuration

The Spatial–temporal Evolution of the Electron Density and Temperature for a Nanosecond Microdischarge

A Large-Area Diffuse Air Discharge Plasma Excited by Nanosecond Pulse under A Double Hexagon Needle-Array Electrode

Nanosecond-Pulse Gliding Discharges Between Point-To-Point Electrodes in Open Air

Numerical Investigation of Runaway Electrons During the Breakdown of Homogeneous Electric Field Air Gaps under Nanosecond Pulse Voltage

An Uniform DBD Plasma Excited by Bipolar Nanosecond Pulse Using Wire-Cylinder Electrode Configuration in Atmospheric Air.

The Evolution of the Optical Emission Pattern of A Nanosecond Pulsed Helium Microdischarge with A Pin-To-Pin Electrode at Atmospheric Pressure

Energetic Electrons and Their Contribution to the Breakdown of a Point-Plane Air Gap with a Positive Nanosecond Pulse

The Breakdown Process in an Atmospheric Pressure Nanosecond Parallel-Plate Helium/Argon Mixture Discharge

Electrical and Optical Characteristics of Diffuse Nanosecond Pulsed Discharge Plasma Using a Needle-Array Electrode in Atmospheric Air

Study on the Electron Emission Process of the Pseudospark During the Hollow Cathode Phase under Nanosecond Pulsed Voltage