Abstract:Dielectric barrier discharge in nitrogen at atmospheric pressure is studied with the spectroscopy and the fast photography of the discharge. By the introduction of a nitrogen flow into the discharge gap, the homogeneous discharge in a 2 mm gap can be maintained. Based on the waveform of the discharge current characterized by a current pulse per half cycle of the applied voltage and the 1 μs exposure discharge photograph showing a luminous layer covering the entire surface of the anode, the homogeneous discharge is identified with a Townsend discharge. The instrumental broadening of the spectrometer used in the experiment is calibrated with a helium-neon laser. The data relevant to the instrumental broadening are input into a code called Specair for calculating the spectrum profiles of 0—2 band in the second positive system of nitrogen molecules at different gas temperatures. By fitting the calculated spectrum profiles to the experimental one, the rotational temperature of the nitrogen molecules is determined. The results show that the dielectric barrier Townsend discharge in nitrogen at atmospheric pressure cannot heat the nitrogen to a high temperature (ΔTg≤50 K) and the small rising in temperature does not induce the thermal instability that leads to the transition of the Townsend discharge to a filamentary discharge. By the addition of a gas flow into the discharge gap, the nitrogen is indeed cooled down to a lower temperature. However, it is not the reason for the Townsend discharge to be maintained. By comparing the discharge spectra with and without the gas flow, it could be concluded that the gas flow much reduces the density of the impurity oxygen desorbed from the dielectric by the discharge and makes it possible for more nitrogen metastables to survive to the beginning time of the next discharge and to provide sufficient seed electrons which are necessary for Townsend discharge.

Characterization of transient discharges under atmospheric pressure conditions applying nitrogen photoemission and current measurements

Characterisation of a 3 nanosecond pulsed atmospheric pressure argon microplasma

Using Oes to Determine Electron Temperature and Density in Low-Pressure Nitrogen and Argon Plasmas

The Transition of Partial Discharge to Homogeneous Discharge in Nitrogen at Low Pressure

Characterization of atmospheric pressure plasma plume

Microsecond pulse gas–liquid discharges in atmospheric nitrogen and oxygen: Discharge mode, stability, and plasma characteristics

Spectroscopic analysis of single and multiphase electrical discharge for clean energy conversion

Influences of Gas Flow on Gas Temperature and Discharge Mode in Dielectric Barrier Discharge of Nitrogen at Atmospheric Pressure

Characteristics of Radio Frequency Dielectric Barrier Discharge Using Argon Doped with Nitrogen at Atmospheric Pressure

Characterization of Atmospheric Pressure Dc Gliding Arc Plasma

Numerical Investigations of Nanosecond Surface Streamers at Elevated Pressure

Characterization Of An Atmospheric Double Arc Argon-Nitrogen Plasma Source

A collisional-radiative model for atmospheric-pressure low-temperature air discharges

Three Modes In The Array Of Surface Microdischarge In Atmospheric Pressure He+N-2 Mixture

[Spectroscopic Study of Atmospheric Pressure Argon DC Microdischarge].

Simulation of Nitrogen Spark Discharge Characteristics under Continuous Nanosecond Pulse at Atmospheric Pressure

Optical diagnostics of a low power—low gas flow rates atmospheric-pressure argon plasma created by a microwave plasma torch

Volume and Surface Memory Effects on Evolution of Streamer Dynamics along Gas/solid Interface in High-Pressure Nitrogen under Long-Term Repetitive Nanosecond Pulses

Diagnostics of atmospheric pressure capillary DBD oxygen plasma jet

OES diagnostics of atmospheric pressure argon plasma: Electron temperature and density assessment through visible bremsstrahlung inversion method and collisional-radiative model

Nanosecond pulsed barrier discharge in argon for various frequencies and theoretical analysis of 2p states density ratios for E/N determination