Abstract:Turnouts on steep ramps are subject to both temperature loads and frequent vehicle braking loads, which may lead to an accumulation of excessive residual longitudinal rail displacement, thereby leading to turnout service failure and threatening vehicle operation safety. In this paper, the following research work was carried out to study the longitudinal rail creep at turnouts on steep ramps: Experiments were conducted to investigate the longitudinal resistance characteristics of fasteners under repeated loading, and based on the experiment results, an MBS-FE simulation model was established for the longitudinal rail creep at turnouts on steep ramps, with real vehicle braking loads and fastener resistance degradation taken into consideration in the model. The change law for longitudinal displacement of turnout rails caused by temperature load and frequent vehicle braking load was studied based on the model. A full-scale experiment was then conducted on the longitudinal rail creep at turnouts on steep ramps under repeated loading conditions in order to verify the results of the simulation. A comprehensive and in-depth study of the longitudinal rail creep at turnouts on steep ramps impacted by repeated loading was conducted through the combination of theoretical analysis and experiment. The following conclusions were drawn: The longitudinal resistance of fasteners displays typical nonlinear characteristics and degrades under repeated loading, these characteristics lead to an obvious accumulation of residual longitudinal displacement of turnout rails on steep ramps under repeated loading, and the increment of residual longitudinal displacement of turnout rails reaches a maximum after the first loading-unloading cycle, and with the increase of the number of load action, the accumulated longitudinal residual displacement of turnout rails increases rapidly in the early stage, and then the growth gradually slows down and eventually stabilizes. The simulation results were found to be very similar to the full-scale experiment results, verifying the accuracy of the analytical model established in this paper.

Investigation of Continuously Welded Rail of Ballastless Longitudinal Stress Distribution of Rail Break

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

On stress and deformation accumulation of continuously welded rails under cyclic thermal loading in high-speed railways

A dynamic analysis of a continuous welded rail track under a longitudinal stress caused by temperature changes

A method for long-term on-line monitoring of temperature stress of continuously welded rail

Study on broken plate force of ballastless track on high-speed railway long-span continuous beam bridge

Investigation of the Fatigue Behaviour of a Ballastless Slab Track–Bridge Structural System under Train Load

Finite Element Analysis of Dynamic Characteristic on Continuous Welded Rail Track under Longitudinal Temperature Force

Combining welding-induced residual stress with thermal and mechanical stress in continuous welded rail

Technical Note: Three-dimensional analyses of dynamic responses of track-ground system subjected to a moving train load

Dynamic constitutive model of U75VG rail flash-butt welded joint and its application in wheel-rail transient rolling contact simulation

Fracture behavior investigation of ballastless track of high-speed railway based on DIC technique

Long-term evolution mechanism of the rail weld irregularity in metro lines based on the wear theory

Mechanical Properties and Structural Optimization of Continuous Welded Rail on Super-Long-Span Suspension Bridges for High-Speed Railway

Evolution of Trackbed Performance and Ballast Degradation Due to Passages of Million Train Wheel Axle Loads

Effect of material non-uniformity and residual stress on wear and transient rolling contact behaviour in laminar plasma quenched (LPQ) rails

Vibration Nondestructive Testing of Continuous Welded Rails: A Finite Element Analysis

Numerical and Experimental Investigation of Longitudinal Rail Creep at Turnouts on Steep Ramps Under Repeated Loads Considering Realistic Braking Loads of Vehicles

Vibration-Based Approach to Measure Rail Stress: Modeling and First Field Test

Evaluating the Effect of Rail Fastener Failure on Dynamic Responses of Train-Ballasted Track-Subgrade Coupling System for Smart Track Condition Assessment

Analysis of Longitudinally Connected Ballastless Track on the High-speed Railway Long-span Bridge Based on the Actual Measured Temperature