Abstract:Bromoalkyl-functionalized poly(olefin)s were synthesized by copolymerization of 4-(4-methylphenyl)-1-butene with 11-bromo-1-undecene using Ziegler-Natta polymerization. The resulting bromoalkyl-functionalized poly(olefin)s were converted to quaternary ammonium-containing anion-conductive copolymers by reacting the pendant bromoalkyl group with trimethylamine or a custom-synthesized tertiary amine containing pendant quaternary ammonium moieties. Poly(olefin)-based AEMs with three cations per side chain showed considerably higher hydroxide conductivities, up to 201 mS/cm at 80 degrees C in liquid water, compared to that of samples with only one cation per bromoalkyl site (68 mS/cm, 80 degrees C, liquid water), likely due to phase separation in the triple-cation structure. More importantly, triple-cation side-chain poly(olefin) AEMs exhibited higher hydroxide conductivity under relative humidity conditions (50%-100%) than typical AEMs based on benzyltrimethylammonium cations. The triple-cation the triple-cation side-chain poly(olefin)-based AEM exhibited an ionic conductivity as high as 115 mS/cm under 95% RH at 80 degrees C and 11 mS/cm under 50% RH at 80 degrees C. In addition to high ionic conductivity, the triple-cation side-chain poly(olefin) AEMs exhibited good chemical and dimensional stability. High retention of ionic conductivity (>85%) was observed for the samples in 1 M NaOH at 80 degrees C over 1000 h. Based on these high-performance poly(olefin) AEMs, a fuel cell with a peak power density of 0.94 W cm(-2) (1.28 W cm(-2) after iR correction) was achieved under H-2/O-2 at 70 degrees C. The results of this study suggest a new, low-cost, and scalable route for preparation of poly(olefin)-based AEMs for anion exchange membrane applications.

Modification of poly(aryl ether ketone) using imidazolium groups as both pendants and bridging joints for anion exchange membranes

Poly (aryl Ether Ketone)/polymeric Ionic Liquid with Anisotropic Swelling Behavior for Anion Exchange Membranes

Poly(olefin)-Based Anion Exchange Membranes Prepared Using Ziegler–Natta Polymerization

Sulfonated Polyaryletherketone with Pendant Benzimidazole Groups for Proton Exchange Membranes

Facile Preparation of Novel Cardo Poly(oxindolebiphenylylene) with Pendent Quaternary Ammonium by Superacid-Catalysed Polyhydroxyalkylation Reaction for Anion Exchange Membranes

Preparation of Poly (aryl Ether) Anion Ionomers with N-Methyl Imidazolium Groups

A novel cross-linked anion exchange membrane with conjugated and non-conjugated pyridine groups

Synthesis of Novel Branched Fluorinated Poly(aryl Ether Oxadiazole)s for Anion Exchange Membranes

Novel Composite Anion Exchange Membranes Based on Quaternized Polyepichlorohydrin for Electromembrane Application

Design of pendent imidazolium side chain with flexible ether-containing spacer for alkaline anion exchange membrane

A Cross-Linked Fluorinated Poly (aryl Ether Oxadiazole) S Using a Thermal Cross-Linking for Anion Exchange Membranes

Two new anion exchange membranes based on poly(bis-arylimidazolium) ionenes blend polybenzimidazole

In-situ synthesis of cross-linked imidazolium functionalized Poly(styrene-b-isobutylene-b-styrene) for anion exchange membranes

High conductivity and alkali-resistant stability of imidazole side chain crosslinked anion exchange membrane

Novel Cross-Linked Anion Exchange Membranes with Diamines As Ionic Exchange Functional Groups and Crosslinking Groups

Preparation and performance study of self‐crosslinking functionalized poly(aryl piperidine) anion exchange membrane

Preparation and Characterization of Fluorinated Poly(aryl Ether Oxadiazole)s Anion Exchange Membranes Based on Imidazolium Salts

Synthesis and characterization of ion exchange capacity controlled and self-crosslinked anion exchange membranes

Facile Synthesis of Poly(arylene Ether Ketone)s with Pendent Oxyhexyltrimethylammonium Groups for Robust Anion Exchange Membranes

Naphthalene-based Poly(arylene Ether Ketone) Anion Exchange Membranes

Fundamental Studies Of A New Series Of Anion Exchange Membranes: Membranes Prepared From Bromomethylated Poly(2,6-Dimethyl-1,4-Phenylene Oxide) (Bppo) And Pyridine