Abstract:Anion exchange membrane fuel cell (AEMFC) has attracting great attention as one of the most clean energy conversion technologies, because it has a facile electrochemical kinetics under alkaline condition and enables the use of non-precious metal catalysts. The reported anion exchange membranes were usually prepared by tethering quaternary ammonium groups (QA) to the backbone of chloromethylated or bromomethylated aromatic polymers by immersing in trimethylamine solution. However, they exhibit much low ionic conductivity and poor alkaline stability, which hinders the further development of AEMFC technology. In order to improve the ionic conductivity of anion exchange membranes, we located multi QA groups on one side chains for enhancing the local density of ionic groups. Therefore, we synthesized a type of small molecule with a quaternary ammonium group and an alkyl bromide. After gethering it onto 1,4-diazabicyclo[2.2.2] octane-functionalized poly(arylene ether ketone) by a quaternization reaction, tri-quaternized poly(arylene ether ketone) (TQPAEK) was successfully prepared with flexible side chains containing multi quaternary ammonium groups. Then a series of anion exchange membranes in OH- form were obtained by solution casting and then alkaline treatment. The ionic exchange capacity of these membranes in the range of 1.75-2.57 meq/g could be adjusted by controlling the degree of bromination of the precursor polymer. The water uptake, swelling ratio and hydroxide conductivity of TQPAEK membranes increased with the increasing IEC values. They also showed good thermal and mechanical stabilities. Especially, the introduction of flexible side chains significantly improved the elongation at the break of membranes, which reached up to 103.2%. Meanwhile, the tensile stress was still higher than 28 MPa. AFM images showed that the hydrophilic/hydrophobic phase-separation morphology was formed in these TQPAEK containing multi-quaternized flexible side chains. Therefore, TQPAEK exhibited high ionic conductivity of 74.35 mS/cm at 80 degrees C. The results indicated that TQPAEK membranes had the potential to be used in alkaline AEMFCs.

Facile Synthesis of Poly(arylene Ether Ketone)s with Pendent Oxyhexyltrimethylammonium Groups for Robust Anion Exchange Membranes

Facile Preparation of Novel Cardo Poly(oxindolebiphenylylene) with Pendent Quaternary Ammonium by Superacid-Catalysed Polyhydroxyalkylation Reaction for Anion Exchange Membranes

Poly(olefin)-Based Anion Exchange Membranes Prepared Using Ziegler–Natta Polymerization

Facile Preparation of an Ether-Free Anion Exchange Membrane with Pendant Cyclic Quaternary Ammonium Groups

Anion Exchange Membranes Based on Tetra-Quaternized Poly(arylene Ether Ketone)

Anion Exchange Membrane Based on Poly(arylene Ether Ketone) Containing Long Alkyl Densely Quaternized Carbazole Derivative Pendant

Synthesis and characterization of long-side-chain type quaternary ammonium-functionalized poly (ether ether ketone) anion exchange membranes

Synthesis and Properties of Quaternized Polyolefins with Bulky Poly(4-Phenyl-1-butene) Moieties As Anion Exchange Membranes

Synthesis and Properties of Poly(arylene Ether Ketone)s with Densely Piperidinium-Functionalized Hexaphenylbenzene Pendants for Anion Exchange Membranes

Poly(arylene ether ketone) with tetra quaternary ammonium carbazole derivative pendant for anion exchange membrane

A High-Performance Anion Exchange Membrane Based on Poly(arylene Ether Sulfone) with a High Concentration of Quaternization Units

Quaternized Poly(Arylene Ether) Ionomers Containing Triphenyl Methane Groups For Alkaline Anion Exchange Membranes

A Comparative Study of Side-Chain-type Poly(ether Ether Ketone) Anion Exchange Membrane Functionalized with Different Hetero-Cycloaliphatic Quaternary Ammonium Groups

Highly Conductive Anion Exchange Membranes with Long Flexible Multication Spacer

Poly(arylene Ether Nitrile) Anion Exchange Membranes with Dense Flexible Ionic Side Chain for Fuel Cells

Investigation on Structure and Properties of Anion Exchange Membranes Based on Tetramethylbiphenol Moieties Containing Copoly(Arylene Ether)S

Synthesis and Properties of a Novel Poly(aryl Ether Ketone)s with Quaternary Ammonium Pendant Groups for Anion Exchange Membranes

Preparation and Properties of Anion Exchange Membranes Based on Multiple Quaternary Ammonium Groups

Pyrrolidinium-functionalized Poly(arylene Ether Sulfone)s for Anion Exchange Membranes: Using Densely Concentrated Ionic Groups and Block Design to Improve Membrane Performance

Quaternized Triblock Polymer Anion Exchange Membranes with Enhanced Alkaline Stability

Comb‐shaped block poly(arylene ether sulfone ketone)s for anion exchange membranes