Abstract:Summary form only given. Exploding wire is performed by rapidly heating the wire to vaporization temperature with a high current pulse flowing through the wire. Exploding wires have found many applications among which are the opening switches named fuses in the circuits for inductive energy storage, the discharge loads of X-pinch or Z-pinches, namely wire array Z-pinches, and the production of nanopowders. The behavior of exploding wires for nanopowder production was studied by experiments and numerical simulation. In experiments, the evolution of the exploding wire was recorded by taking time- resolved pictures of the explosion with a Mach-Zehnder interferometer. From the interferograms the electron density and the expansion speed of the metallic vapor from the exploding wire can be deduced. The shock wave in front of the expanding wire could be visualized. In numerical simulation, the electrical behavior of exploding wires was obtained by solving nonlinear differential equation describing the discharge circuit. For the metal wires of high conductivity and low sublimation heat, such as Copper, Aluminum, Gold and Silver, the circuit simulation could be well conducted based on the resistivity model developed by Tucker1 in which the resisitivity was expressed with the explicit functions of specific action, i.e., p = f(g) . For the metals such as Titanium and Zinc of their resistivity anomalously changing, i.e., decreasing rather than increasing, with the liquid heating, the circuit simulation of the exploding wires could be performed using the implicit relationship between p and g that is read out point by point from the experimentally measured curve. With the circuit simulation the rate of the energy deposition in the exploding wires before the explosion could be obtained, which is helpful to choose right experimental conditions for possible overheat that is desirable for getting smaller nanopowders produced by exploding wires.

The Development of Coated and Non-Coated Wire Explosions Observed by X-Ray Backlighting

Mass Density Evolution of Wire Explosion Observed Using X-Ray Backlight

Measurement of the mass density evolution of wire explosion using X-ray backlight

X-ray Backlighting of Wire Expansion and Plasma Merging of Z-Pinch Load with 10-40Ka/wire

Study on Electrical Explosion of Bare and Insulation Coated Tungsten Wires

Measuring the Evolution of Mass Density Distribution of Wire Explosion

X-Ray Backlighting of Developments of $X$ -Pinches and Wire-Array $Z$ -Pinches Using an $X$ -Pinch

X-ray Backlighting of the Initial Stage of Single-Wire and Multi-Wire Z-pinch

X-ray backlighting of two-wire Z-pinch plasma using X-pinch

Behavior of exploding wires

The Explosive Eletrical Characteristics Test Research on Electric Exploding Copper Wire

Research at Tsinghua University on electrical explosions of wires

Nano-powder Production by Electrical Explosion of Wires

High-Speed Imaging of Transition from Fluid Breakup to Phase Explosion in Electric Explosion of Tungsten Wires in Air

Axial Backlighting of Two-Wire Z-pinch Using an X-pinch As an X-ray Source

Evolution of the Exploding Titanium Wire in 5-50 Kpa Ambient Gas

Study of the Relationship Between Maximum Specific Energy and Wire Diameter During Electrical Explosion of Tungsten Wires

X-ray emission from an X-pinch and its applications

End-On X-Ray Backlighting Experiments for Axial Diagnostics of Wire-Array Z-Pinch Plasma on Ppg-1

Electrical Explosion Across Gas–liquid Interface: Aerosol Breakdown, Shock Waves, and Cavity Dynamics

Fully Vaporized Electrical Explosion of Bare Tungsten Wire in Vacuum