Abstract:Controlled/living radical polymerization (CLRP) is one of the most rapidly developing areas in polymer science, and among the various existing techniques, nitroxide-mediated polymerization (NMP) was the first to be proposed. Most researches focused on the development of aliphatic nitroxide while few studies were devoted to the use of aromatic nitroxides in NMP. This paper describes nitroxide-mediated radical polymerization of methyl methacrylate (MMA) in the presence of 4, 4'-dimethoxydiphenyl nitroxide (DMDPN) and azobisisobutyronitrile (AIBN). The aromatic nitroxide was synthesized by oxidation of 4, 4'-dimethoxydiphenyl amine with oxone under biphasic conditions (CH2Cl2/H2O) in rapid and good yields. The bulk polymerization of MMA was conducted in sealed glass tubes at different conditions. The polymerization kinetics was monitored by gravimetric method while the molecular weight and its distribution of poly (methyl methacrylate) (PMMA) synthesized were determined by gel permeation chromatography. The effects of the nitroxide/initiator ratio and polymerization temperature on the polymerization kinetic, molecular weight and polydispersity index (PDI) of PMMA were investigated in detail, and reinitiation reaction experiment was conducted to verify the chain-end activity. The results showed that in this polymerization system, as the DMDPN allows delocalization of the single electron through the aromatic ring, the side reaction of beta-H transfer from the propagating macroradicals to the free nitroxide which would hinder the propagating process, was neglected and the chain propagation in MMA polymerization could be efficiently controlled. Molecular weight of PMMA increased linearly with monomer conversion at different DMDPN/AIBN ratios and temperatures which was different from common radical polymerization. The PMMA could be reinitiated which showed the characteristics of controlled/living radical polymerization. The polymerization rate was quite fast at low DMDPN/AIBN ratios and an induction period appeared when the ratio was too high. At the DMDPN/AIBN ratio of 1.6, the PDI was the lowest and the curve of ln(M-0/M) versus time was a straight line which crossed the coordinate origin. The polymerization rate increased and PDI decreased as the polymerization temperature increased. MMA polymerization could even been operated at 70 degrees C though the PDI was relative higher.

Cuso4-Amine Redox-Initiated Radical Polymerization of Methyl Methacrylate Mediated by A Cucl2 Complex: Homogeneous Reverse Atrp

Alkyl Halide/tertiary Amine As Novel Initiators for Free Radical Polymerizations of Methyl Methacrylate, Methyl Acrylate and Styrene

"Living" Radical Polymerization of Methyl Methacrylate Using CuBr as Catalyst in [Hmim][CH_3COO]

Living Radical Polymerization Of Methyl Methacrylate Catalyzed By Cuprous N,N-Diethyldithiocarbamate

Reserve atom transfer radical polymerization using AIBN or BPO as initiator

Reverse atom transfer radical polymerization using BPO as the initiator

Reverse atom transfer radical polymerization of methyl methacrylate in imidazolium ionic liquids

Visible-light induced controlled radical polymerization of methacrylates with Cu(dap)2Cl as a photoredox catalyst

Dispersion Atom Transfer Radical Polymerization of Vinyl Monomers in Supercritical Carbon Dioxide

Atom Transfer Radical Polymerization of Methyl Methacrylate by Silica Gel Supported Copper Bromide/Multidentate Amine

Reverse Atom Transfer Radical Polymerization Of Methyl Acrylate Using Aibn As The Initiator Under Heterogeneous Conditions

Methyl Methacrylate Polymerization Mediated by 4,4 '-Dimethoxydiphenyl Nitroxide Free Radicals

Neutral Pd(II) and Ni(II) Acetylide Catalysts for the Polymerization of Methyl Methacrylate

Reverse Atom-Transfer Radical Polymerization at Room Temperature

In-Situ Heterogenous Polymerization of Methyl Methacrylateonto Nanometer Calcium Carbonate Particles

A Plasma-Initiated Graft Polymerization of Methyl Methacrylate in the Presence of a Reverse ATRP Catalyst

Supported atom transfer radical polymerization of methyl methacrylate mediated by CuBr-tetraethyldiethylenetriamine grafted onto silica gel

Synthesis of Amphiphilic Poly(ethylene oxide)- b -Poly(methyl methacrylate) Diblock Copolymers via Atom Transfer Radical Polymerization Utilizing Halide Exchange Technique

Synthesis of Amphiphilic Poly(methyl Methacrylate)‐block‐poly(methacrylic Acid) Diblock Copolymers by Atom Transfer Radical Polymerization

Synthesis of Methacrylate Macromonomers Using Silica Gel Supported Atom Transfer Radical Polymerization

Reverse Atom Transfer Radical Polymerization Of Methyl Methacrylate In Room-Temperature Ionic Liquids