Abstract:RAFT polymerization is a type of psudo-living radical polymerization. In order to synthesize high pure block copolymers by RAFT polymerization, it is desirable to suppress the irreversible termination which may result in the formation of dead chains. For polymers less than 5 x 10(4) g/mol, the dead chain fraction could remain to be lower than 0.1 by reducing the initiator concentration. In the synthesis of block copolymers, the dead chains formed in the first stage are actually contaminant. Targeting to the synthesis of high pure block copolymers with high molecular weight using RAFT polymerization, we studied the copolymerization of butyl acrylate and styrene mediated by 1-phenylethyl phenyl-dithioacetate (PEPDTA) as a RAFT agent. The influences of the type of initiators (AIBN (2-2'-azobis ( isobutyronitrile)), ACC ( 1-1'-azobis ( cyclohexane-carbonitrile)), the concentrations of initiator and polymerization temperature on the copolymerization kinetics and molecular weight and its distribution were investigated. When AIBN was used, the polymerization would stop at middle monomer conversion, which limited the increase of molecular weight of the copolymer if we reduced the initiator concentration. It was found that only with the initiator (ACC) with small decomposition rate constant and high polymerization temperature, the block copolymer with high molecular weight and small fraction of dead chains ( < 0.1) could be synthesized. The reason for these quite strict requirements is that the initiator concentration should remain far below that of the conventional radical polymerization, which is limited by the very low RAFT concentration.

Correlation Between Polydispersities of Molecular Weight Distribution and Particle Size Distribution in RAFT Emulsion Polymerization of Styrene

Particle activation/deactivation effect in RAFT emulsion polymerization of styrene

Modeling and Experimentation of RAFT Solution Copolymerization of Styrene and Butyl Acrylate, Effect of Chain Transfer Reactions on Polymer Molecular Weight Distribution

Toward well-controlled ab initio RAFT emulsion polymerization of styrene mediated by 2-(((Dodecylsulfanyl)carbonothioyl)sulfanyl)propanoic acid

Reversible addition fragmentation transfer (RAFT) polymerization of styrene in a miniemulsion: A mechanistic investigation

Tailoring Uniform Copolymer Composition Distribution Via Policy II RAFT Solution Copolymerization of Styrene and Butyl Acrylate

110Th Anniversary: Model-Guided Preparation of Copolymer Sequence Distributions Through Programmed Semibatch RAFT Mini-Emulsion Styrene/Butyl Acrylate Copolymerization

Branching in Raft Miniemulsion Copolymerization of Styrene/Triethylene Glycol Dimethacrylate and Control of Branching Density Distribution

The Influence of Surfactant Coverage of the Minidroplets on Raft Miniemulsion Polymerization

Ab Initio Emulsion and Miniemulsion Polymerization of Styrene Mediated by a Cyclohexenyl-Functionalized Amphiphilic RAFT Agent

Ab Initio Batch Emulsion Raft Polymerization Of Styrene Mediated By Poly(Acrylic Acid-B-Styrene) Trithicicarbonate

RAFT Ab Initio Emulsion Copolymerization of Γ-Methyl-α-methylene-γ-butyrolactone and Styrene

Kinetics of RAFT Emulsion Polymerization of Styrene Mediated by Oligo(acrylic Acid‐b‐styrene) Trithiocarbonate

Synthesis of Well-Defined Polystyrene with Molar Mass Exceeding 500 kg/mol by RAFT Emulsion Polymerization

Reversible addition–fragmentation chain transfer polymerization of methyl methacrylate in emulsion

The Synthesis of High Molecular Weight Block Copolymers by Raft Polymerization

Reversible Addition–fragmentation Transfer (RAFT) Copolymerization of Methyl Methacrylate and Styrene in Miniemulsion

Ab initio RAFT emulsion polymerization of butadiene using the amphiphilic poly(acrylic acid-b-styrene) trithiocarbonate as both surfactant and mediator

Modeling of Branching and Gelation in RAFT Copolymerization of Vinyl/Divinyl Systems

Significantly Suppressed Chain Transfer to Monomer Reactions in RAFT Emulsion Polymerization of Styrene

Ab Initio RAFT Emulsion Copolymerization of Styrene and Acrylonitrile