Abstract:A new solid-contact ion-selective electrode (ISE) sensitive to lead (II) ions, obtained by modifying a polymer membrane with a nanocomposite of carbon nanofibers and an ionic liquid 1-hexyl-3-methylimidazolium hexafluorophosphate, is presented. Electrodes with a different amount of nanocomposite in the membrane (0–9% w/w), in which a platinum wire or a glassy carbon electrode was used as an internal electrode, were tested. Potentiometric and electrochemical impedance spectroscopy measurements were carried out to determine the effect of the ion-sensitive membrane modification on the analytical and electrical parameters of the ion-selective electrode. It was found that the addition of the nanocomposite causes beneficial changes in the properties of the membrane, i.e., a decrease in resistance and an increase in capacitance and hydrophobicity. As a result, the electrodes with the modified membrane were characterized by a lower limit of detection, a wider measuring range and better selectivity compared to the unmodified electrode. Moreover, a significant improvement in the stability and reversibility of the electrode potential was observed, and additionally, they were resistant to changes in the redox potential of the sample. The best parameters were shown by the electrode obtained with the use of a platinum wire as the inner electrode with a membrane containing 6% of the nanocomposite. The electrode exhibited a Nernstian response to lead ions over a wide concentration range, 1.0 × 10−8–1.0 × 10−2 mol L−1, with a slope of 31.5 mV/decade and detection limit of 6.0 × 10−9 mol L−1. In addition, the proposed sensor showed very good long term stability and worked properly 4 months after its preparation without essential changes in the E0 or slope values. It was used to analyze a real sample and correct results of lead content determination were obtained.

A glassy carbon electrode modified with antimony and poly(p-aminobenzene sulfonic acid) for sensing lead(II) by square wave anodic stripping voltammetry

Layer-By-Layer Assembly of Poly(P-Aminobenzene Sulfonic Acid)/Quaternary Amine Functionalized Carbon Nanotube/P-Aminobenzene Sulfonic Acid Composite Film on Glassy Carbon Electrode for the Determination of Ascorbic Acid

Synthesis of MnCo2O4 nanoparticles as modifiers for simultaneous determination of Pb(II) and Cd(II)

A glassy carbon electrode modified with a bismuth film and laser etched graphene for simultaneous voltammetric sensing of Cd(II) and Pb(II)

Pyridine-2-sulfonic (or carboxylic) acid modified glassy carbon electrode for anodic stripping voltammetry analysis of Cd2+ and Pb2+

Bismuth-Coated Thick-Film Carbon Electrodes for the Detection of Lead and Cadmium by Anodic Stripping Voltammetry

Voltammetric Sensing of Pb(II) Using a Glassy Carbon Electrode Modified with Composites Consisting of Co3O4 Nanoparticles, Reduced Graphene Oxide and Chitosan

Square Wave Anodic Stripping Voltammetry Applied to a Nano-Electrode for Trace Analysis of Pb(II) and Cd(II) Ions in Solution

Microdroplet Anodic Stripping Voltammetry at the in situ Preparing Antimony‐Modified Rotating Disk Electrode for Determination of Cd(II) and Pb(II)

Use of a Schiff base-modified conducting polymer electrode for electrochemical assay of Cd(II) and Pb(II) ions by square wave voltammetry

An Efficient Voltammetric Sensor Based on Graphene Oxide-Decorated Binary Transition Metal Oxides Bi2O3/MnO2 for Trace Determination of Lead Ions

High Sensitivity and Reproducibility of a Bismuth/Poly(bromocresol Purple) Film Modified Glassy Carbon Electrode for Determination of Trace Amount of Cadmium by Differential Pulse Anodic Stripping Voltammetry

Screen-Printed Carbon Electrode Modified with Carbon Nanotubes and Copper Film as a Simple Tool for Determination of Trace Concentrations of Lead Ions

[Clinical application of fast protein liquid chromatography (FPLC) system].

Ultra-sensitive simultaneous electrochemical detection of Zn(II), Cd(II) and Pb(II) based on the bismuth and graphdiyne film modified electrode

Simultaneous Determination of Copper, Lead, and Cadmium Ions at A Mo6s9-Xix Nanowires Modified Glassy Carbon Electrode Using Differential Pulse Anodic Stripping Voltammetry

Super-efficient and stable detection of toxic heavy metal by polyethylenimine-modified graphene electrode sensor

[Radioimmunoassay of proteohormones (growth hormone, insulin, etc.)].

Improved Lead Sensing Using a Solid-Contact Ion-Selective Electrode with Polymeric Membrane Modified with Carbon Nanofibers and Ionic Liquid Nanocomposite

High-Sensitivity Determination Of Lead And Cadmium Based On The Nafion-Graphene Composite Film

Stripping voltammetric determination of cadmium and lead ions based on a bismuth oxide surface-decorated nanoporous bismuth electrode