Abstract:Investigations made by the authors and collaborators into the microstructural and fracture aspects of adiabatic shear bands (ASBs) of the hardened steels and Ti alloys induced by high speed machining (HSM) are briefly reviewed. The principal findings are the following: (a) the microstructure inside the ASBs varies from the band center to the normal chip material, the gradient microstructures are found; (b) the HSM can produce two types of ASBs with increasing in cutting speed, the deformed shear bands formed at lower cutting speed and the transformed shear bands formed at higher cutting speed; (c) the very small equiaxed recrystallized grains are observed in the center of the ASBs, the dynamic recrystallization and phase transformation may occur simultaneously during the formation of the transformed ASBs; (d) The dynamic rotational recrystallization is the origin of the equiaxed grains in the center of the ASBs. A microstructural evolution model in ASBs produced during HSM for the harden steel is proposed; (e) the microstructural pattern of fracture surface is characterised by the elongated dimples. A microcosmic adiabatic shear fracture model during HSM of the hardened steel is built up.

Component Analysis of Adiabatic Shear Band Formed in High Speed Cutting of High Strength Alloy Steel

Finite Element Analysis of Adiabatic Shear Band Formation in Titanium Alloy Cutting Process

Adiabatic Shear Bands in 30crni3mov Structural Steel Induced During High Speed Cutting

Study on Chip Morphology and Adiabatic Shear in High Speed Cutting of Alloy Steels with Different Hardness

An Investigation into the Microstructure of Adiabatic Shear Banding in AISI 1045 Hardened Steel Due to High Speed Machining

Microstructural Study of Adiabatic Shear Bands Formed in Serrated Chips During High-Speed Machining of Hardened Steel

Understanding The Deformation Of Metals In High Speed Cutting

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Adiabatic Shear Localization in High Speed Cutting of Hardened Steel

Research on Shear Deformation Localization in High-Strength Steel During Orthogonal Cutting

Adiabatic Shear Banding in Aisi 1045 Steel During High Speed Machining: Mechanisms of Microstructural Evolution

Research on Adiabatic Shear During Serrated Chip Formation of High Speed Turning of Hardened Steel

Microstructure Characteristics of the Adiabatic Shear Bands in Serrated Chips of 30crni3mov Steel

Some metallurgical observations of adiabatic shear phenomenon during high speed machining AISI 1045 hardened steel

Some metallurgical aspects of chips formed in high speed machining of high strength low alloy steel

Microstructure observation of adiabatic shear bands in cutting low alloy steel

Effect of cutting conditions on the serrated chip formation in high-speed cutting

A review of microstructural evolution in the adiabatic shear bands induced by high speed machining

Ductile Fracture Due to Adiabatic Shear During the Serrated Chip Formation in High Speed Cutting: a Microscopic Investigation

Finite element simulation of the formation process of a serrated chip in high-speed cutting

Study on cutting force under serrated chip formation and adiabaitic shear instability during high speed turning of AISI 1045 hardened steel