Abstract:In order to optimize the production regime for effective coatings of required thickness on Ti6Al4V surface, a comparative study was made on the kinetics of ceramic coatings growth, and was associated with the evolution of microstructure and phase composition during microarc oxidation (MAO) under constant voltage and constant current density regime, respectively, using an Ac pulse power supply in Na2SiO3–KOH–(NaPO3)6 solution. The thickness of the resulting coatings was measured using a coating thickness gauge based on eddy principle. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) were employed to characterize the microstructure and phase composition of the coatings. The results show that as treatment time increases, the coating grows in an exponential function accompanied by a gradually decaying current density for constant voltage control mode (U=500 V), For constant density control mode (J=60 mA/cm2), voltage increases rapidly up to a relatively stable value and the coating grows linearly; compared with the constant voltage mode, the coating grows faster. Phase composition and microstructure evolution during MAO process are almost independent of control mode. With increasing treatment time, the predominant phase composition varies from anatase to rutile, which indicates that phase transformation of anatase into rutile occurs in the duration of oxidizing process. Meanwhile, the size of micropores existing on the coating surface increases and thus the surface becomes much coarser.

Formation Process of Ti Coatings in Mechanical Coating with Different Rotation Speed

Preparation of Metal Coatings on Steel Balls Using Mechanical Coating Technique and Its Process Analysis

S0430204 Formation and Its Process Analysis of Metal Films by Mechanical Coating Technique

Fabrication of Sn Coatings on Alumina Balls by Mechanical Coating Technique and Relevant Process Analysis

Effect of substrate rotational speed during deposition on the microstructure, mechanical and tribological properties of a-C:Ta coatings

Influence of Oxidation Process on Photocatalytic Activity of Photocatalyst Coatings by Mechanical Coating Technique

Mechanical Coating Technique and Its Development As a Novel Film Formation Process

The influence of the processing parameters on the formation of iron thin films on alumina balls by mechanical coating technique

Influence of Metal Properties on the Formation and Evolution of Metal Coatings During Mechanical Coating

Effects of Substrate Rotation Speed on Structure and Adhesion Properties of CrN/CrAlSiN Multilayer Coatings Prepared Using High-Power Impulse Magnetron Sputtering

Fabrication and Photocatalytic Activity of Photocatalyst Coatings by Mechanical Coating Technique and the Oxidation at Relatively Low Temperatures

Process study of TiO2 coating on Al2O3 particles by chemical vapor deposition technology

Fabrication of Zinc Coatings on Alumina Balls from Zinc Powder by Mechanical Coating Technique and the Process Analysis

Growth, Microstructure and Mechanical Properties of Microarc Oxidation Coatings on Titanium Alloy in Phosphate-Containing Solution

Microarc Oxidation Coatings Formed on Ti6Al4V in Na2SiO3 System Solution: Microstructure, Mechanical and Tribological Properties

Dependence of Growth Features of Microarc Oxidation Coatings of Titanium Alloy on Control Modes of Alternate Pulse

Photocatalytic Activity of Tio2/Ti Composite Coatings Fabricated by Mechanical Coating Technique and Subsequent Heat Oxidation

Influence of Oxidation Temperature on Photocatalytic Activity of Cr-TiO2 Coatings by Mechanical Coating Technique

A Study of the Oxide Layer on the Surface of a TiN Coating

Surface Performance of Nano-CrN/TiN Multi-Layered Coating on the Surface of Ti Alloy

Ti-Al amorphous composite coating prepared by mechanical alloying method